Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

OT: Got an antique lawnmower

Posts

OT: Got an antique lawnmower

#1

OT: Got an antique lawnmower

Don henthorn

>that I want to use. It has a cooling fin broken off the flywheel which causes the motor to vibrate because of unbalance. It is unlikely I can find a replacement flywheel for the old motor so I need to cut off an opposing fin to bring the flywheel back into balance. What kind of wheel would be best for cutting the cast iron, carbide or diamond? I plan on using my little Dremel type tool to do the cutting.

Re: OT: Got an antique lawnmower

#2

Re: OT: Got an antique lawnmower

Chuck W

>what if instead of breaking of a fin you drilled some holes in the flywheel to balance it?

Re: OT: Got an antique lawnmower

#3

I think it is too big a piece to balance that way.

Don henthorn

>Here is a pic.


Re: OT: Got an antique lawnmower

#4

Re: I think it is too big a piece to balance that

Bill Falberg

>Dremels have really cool little 1.25" cut-off wheels that would work perfectly for getting in there to cut it off. I'd suggest cutting it at the same place and angle as the other side. Gotta love that old iron, eh?

Re: OT: Got an antique lawnmower

#5

Re: OT: Got an antique lawnmower

DB

>Have you tried getting a replacement flywheel? Most of the small motors have not changed that much, so the parts my be interchangable. Try a small motor repair shop that has been around a long time, or even an old hardware store if you can find one.

Cutting off another fin will not really balance it, try adding weight to where the fin was.

Re: OT: Got an antique lawnmower

#6

This is an old Tecumseh engine.

Don henthorn

>I replaced the short block about forty years ago. Some parts can be found. I haven't been able to find a replacement that I was sure was the same. Unfortunately I sold all my tools a couple of years ago and I don't have the equipment to remove the flywheel. The shops around this bedroom community can only handle simple replacement of parts for fairly recent machines. I have to drive over an hour to find a welding shop that will take small jobs. It is the pits.

Re: OT: Got an antique lawnmower

#7

Re: This is an old Tecumseh engine.

Ron Hildreth, Alta, Iowa

>Don,

I think I would take it to your local motorcycle shop and see if their wheel mechanic can estimate how much weight you need to balance your fly wheel. Motorcycles utilize a stick on type weight. If this doesn't work, it's easily removed and you can start over again, nothing harmed.

Ron in Iowa