Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Cleaning old clamps

Posts

Cleaning old clamps

#1

Cleaning old clamps

Nick Barnes

>I recently acquired some old steel bar clamps from my grandfather. They have been sitting in a detached garage for at least 10 years, and they have a coating of rust on them. I know that they will need some elbow grease, but I don't know the best way to go about cleaning them.

One idea I have is to use some WD-40 and steel wool. Is this the best bet? What grade steel wool should I use?

I'm open to any and all suggestions. I would like to try to restore them and begin a collection of sorts.

Thanks in advance,

Nick in St. Louis

Re: Cleaning old clamps

#2

The best general purpost rust remover

Forrest Addy

>The best general purpost rust remover is a 4" angle grinder with a 3" wire cup wheel on it. You can be as harsh or as careful as you wish. You will have to use care around the clamp threads. A wire wheel when forced into the thread spaces to get the last dab of rust can blur the profile considerably.

Re: Cleaning old clamps

#3

Re: Cleaning old clamps

George@Colonel's Workshop-Havertown PA

>Good Evening Nick,

Of course Forrest is correct. When faced with a bonanza of cast off clamps a few years ago, all I had was a tailed 1/4" drill and a wire brush. I am using the clamps today (and did use one of them today for sure). I'd probably spray it with WD=40 and attack as Forrest recommends.

George

Re: Cleaning old clamps

#4

THE best stuff for Cleaning old clamps

del schisler

>http://www.theruststore.com/Boeshield-Rust-Free-845-oz-Spray-P2C1.aspx

this is the best stuff you can get It is mfd by boeing aircraft co. also get this also http://www.woodcentral.com/newforum/msgset.shtml

some of the catalogs have them in a set cheeper than single I have used these Nothing else is better It also come's in gal. A friend has tool's that he sell's Sure makes them look like new You won't belive how good it works del

Re: Cleaning old clamps

#5

Re: THE best stuff for Cleaning old clamps *LINK*

Nick Barnes

>Thanks for all of the great advice. I just picked up the double pack of Boeshield T-9 and their rust remover. I would like to re-surface my table saw with the T-9, but I have previously coated it with paste wax. Should I do some surface prep to remove the paste wax? If so, what do you think would be the best method?

Thanks in advance,

Nick


Boeshield at Sears