Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

OT (?) Counter top . . .

Posts

OT (?) Counter top . . .

#1

OT (?) Counter top . . .

SteveM

>Contractor told family member he could remove the old Formica veneer from the kitchen counter and replace it. Mow I've no doubt it could be done with many hours of chiseling, cleaning, sanding, etc but cost effective ? Never done it myself but I watched Ol' Norm put some on with contact cement and it looked like this stuff was'nt going to come off without a fight. Am I off-base ?

Re: OT (?) Counter top . . .

#2

Re: OT (?) Counter top . . .

Nat Robison

>While I've never done it, I think I've read that new Formica can be laid over old without removing the first layer. I think it helps to scuff the old Formica for better adhesion.

Re: OT (?) Counter top . . .

#3

Re: OT (?) Counter top . . .

Barry Irby

>You can scuff sand the old and install new over it.

You can remove the Old if it was glued on with contact cement by standing the CT on its edges and soaking the joint with lacquer thinner. Once you get a putty knife or knife blade into the joint, pour in a little lacquer thinner and let it soak. keep prying it apart and adding more thinner and it will come off. At least it will when they are fairly new. Don't know if it works if they are real old. Doubt if ti will work on the post formed stuff with the rolled edges.

Re: OT (?) Counter top . . .

#4

Re: OT (?) Counter top . . .

DB

>It can be done with a lot of hard work, but for my money I would remove and replace the substrate. Another way is to just lay the new plastic laminate over the old, that is if the old is still in good condition.

Re: OT (?) Counter top . . .

#5

Re: OT (?) Counter top . . .

Moses Yoder in White Pigeon, MI

>Is the contractor wanting to remove the laminate, or the family member? If someone were to ask me whether laminate can be removed from the substrate I would say yes, and it would be done as previously described with laquer thinner relatively easily. But if I were putting new counters in my house I would use a new substrate because of the small cost of the new substrate compared to the labor involved plus the questionable results of reusing a substrate.

Re: OT (?) Counter top . . .

#6

I sent your opinions . . .

SteveM

>along to " Auntie ". They're learning the lingo and what to ask of a contractor. Your responses just helped out the learning curve ! Aunt Mamie ( no joking ! ) said to tell all here " Thank You ! ".