Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Another Shellac Question?

Posts

Another Shellac Question?

#1

Another Shellac Question?

Barry Irby

>I have been finishing my Huntboard with Shellac. Using Zinzer Seal Coat.

I have brushed it on and am happy with it except on the top. The large flat surface seems to magnify any defects.

I sanded the top nice and flat with 320 sand paper. I also did a test piece. (About 4 x 18") Put the Seal Coat on with a pad.

The sample looked good. Did a drawer front. Looked good. Did the top. Looks like syrup drying. Sort of gooey looking.

I think I put too much on. I think I did not thin it enough. How much do you thin Seal Coat?

When you wipe it on do you pad it and leave some "pad" marks and buff them out later and wax? I can't seem to get the last coat to level out and have a nice even sheen.

Re: Another Shellac Question?

#2

Re: Another Shellac Question?

George@Colonel's Workshop-Havertown PA

>Barry,

I sounds to me that the problem stems from too heavy a mix of shellac with alcohol. Splash a little alcohol in it and it will flow out much easier. Also, you may be trying to apply too much at one time. You don't want to create ridges/dry edges where the pad has been. You will spend a lot of time leveling out. Thin and even coats, and a very light touch and keep the pad moving.

George

Re: Another Shellac Question?

#3

Re: Another Shellac Question?

Steve Schoene

>Seal Coat is only two point cut, which is usually applies pretty well, though there isn't anything wrong with adding a dollop of DNA. The key is to move quickly without ever stopping on the surface or going back to to touch a spot a second time. Nothing wrong either with applying a number of "coats" and then smoothing any with sandpaper before putting on a last coat or two to restore the gloss. Shellac rubs out quite well, so you can eliminate any defects in the rub out process and bring it to any gloss that you want.

Re: Another Shellac Question?

#4

Re: And the thing to remember is...

Glenn Madsen near San Francisco

>the coats all blend together. There are no 'layers'. You can rub, level, sand, scrape, blend, whatever, and not have intermediate layer issues.

I would add: Work early in the day, if you can, before it warms up too much. Fast drying is not your friend, in my experience. And make sure that the perviously applied finish has gotten hard, if at all possible. You'll become a much better finisher!

Re: Another Shellac Question?

#5

Re: And the thing to remember is...

Dan Donaldson

>I usually mix my own and when I am doing a large surface, I use behlcol (sp?) instead of straight alcohol to slow down the drying time a bit. Makes it easier to prevent overlap marks.

Re: Another Shellac Question?

#6

Re: And the thing to remember is...

John Pappas

>My understanding is that a dribble (1 teaspoon per 4 ounces) of pure turpentine (not the synthetic type) can be used to slow shellac down.