Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Johnsons Paste Wax On Top Of Tung Oil

Posts

Johnsons Paste Wax On Top Of Tung Oil

#1

Johnsons Paste Wax On Top Of Tung Oil

Dave's Not Here

>I'm putting the final touches on a chess board that my son asked me to make for him. As I had never used tung oil in the past I decided to give it a try on this project.

When finished I'll have 8 coats of tung oil on it and was wondering if a coat or two of Johnsons Paste Wax on top of tung oil would add anything to the finish process. Any thoughts on doing this? Thanks.

Re: Johnsons Paste Wax On Top Of Tung Oil

#2

Re: Johnsons Paste Wax On Top Of Tung Oil

George@Colonel's Workshop-Havertown PA

>Good Afternoon Dave,

There may be no really significant improvement to the finish, except the chess pieces should slide more easily over the board's surface, making the game a bit faster. :<)

George

Re: Johnsons Paste Wax On Top Of Tung Oil

#3

Re: Johnson's Paste Wax On Top Of Tung Oil

David Yoho

>For this application, Dave, I'd be inclined to skip the paste wax.

David

Re: Johnsons Paste Wax On Top Of Tung Oil

#4

Re: Johnsons Paste Wax On Top Of Tung Oil

Howard Acheson

>A question. Did you use a real, 100%, pure tung oil or one of the faux tung oil finishes like Minwax Tung Oil Finish?

The reason for asking is that pure tung oil with that many coats will take 3-4 weeks to fully cure. You should not put a wax on it until it has fully cured or the off gassing will prevent the wax from hardening.

Re: Johnsons Paste Wax On Top Of Tung Oil

#5

Re: Johnsons Paste Wax On Top Of Tung Oil

Moses Yoder in White Pigeon, MI

>I normally use a mixture of tung oil and poly and thinner for finishing. My last step is usually rubbbing it out with a 0000 steel wool with paste wax. This normally lowers the gloss and makes a nice even sheen across the whole piece and gives it a nice feel when you touch it. If you are putting 7 or 8 coats on and you like the sheen and have an even sheen you would not need to put the paste wax on. If the board gets scratched up during use rubbing it out with paste wax would be an easy way to renew the finish. I would suggest finishing a scrap piece while you are doing the chess board and then you can experiment a bit with the paste wax after you are done finishing.

Re: Johnsons Paste Wax On Top Of Tung Oil

#6

Re: I don't like Johnsons, use furniture wax

Peter Gregory

>I find Johnson's Wax to stiff and hard to apply. The whole thing is easier with furniture wax from the woodworking store.

Not saying you should use it here though. Comes down to how shiny you want the finished piece.

Re: Johnsons Paste Wax On Top Of Tung Oil

#7

Thanks Howard

Dave's Not Here

>Howard, thanks for that little bit of info, I didn't realize that it would take that long to fully cure.

Re: Johnsons Paste Wax On Top Of Tung Oil

#8

not quite true, and why you smell it

Michael Dresdner

>Sorry to be a prig, but there are no solvents in pure tung oil and there is no reaction product that can 'off gas.' I think what Howard meant to say was that the wax can slow down the cure of the oil, and that is true, but there is nothing in tung oil that can affect the cure of the wax. That's because wax 'dries' solely by solvent evaporation, and pure tung oil cures solely by oxygen polymerization. Unless you mix the two while wet, the oil has no effect on the wax. Wax, on the other hand, can slow down how quickly oxygen can get into the oil to cure it, and that can slow the curing process, so his advice is right even though his explanation is slightly flawed.

For the record, the term off gassing refers to gasses created as reaction byproducts of a chemical reaction in finishes. Hydrogen is the most common one by far in finishes.

That naturally raises the question "So if it is not off gassing, why can I smell the wet tung oil?" The answer is that until it cures to a solid, molecules of tung oil are able to escape into the air much like water molecules become water vapor in the air. As long as they are airborne the molecules can reach you nose and you will smell it. Yes, that means that when you smell feces your nose is actually taking in molecules of... oh, never mind. No need to go there.