Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Plunge router

Posts

Plunge router

#1

Plunge router

J Runchey

>I could use a plunge router on occasion and was wondering if I should get a plunge base for my 690 PC. Do these work well, or would

I be better off buying a dedicated plunge r. like the Bosch 2 HP. I seem to recall some negative comments about bad performing p bases for some PC models, but can't remember any details.

Re: Plunge router

#2

Re: Plunge router

R. Lance in GR, Michigan

>I have the PC plunge base for the series 690 motors and also use it occasionally and I find it to be completely adequate for any plunge routing task that I've had to do including making mortices, cutting thru slots in jigs, making shelf pin holes, etc. Its part of the PC 690 system and takes PC guide bushings, base plates, and fences. The only problem I've found is that the motor can be hard to remove from this base if you allow the motor to bottom out on the base when you initially install it....so just keep the motor 1/2" above the base when you tighten it down and this little offset eliminates the problem of motor removal. Without question, there are many dedicated plunge routers that are better than this combination....but for occasional use, this will get the job well done.

Re: Plunge router

#3

No problems here.

Ray Thompson - Middletown,IN

>

Re: Plunge router

#4

I agree.

Rod Peterson -- Ormond Beach

>When you get to the embarrassment of riches point and can have a couple of 690 motors, keep one in the 693 base all the time. Then there's no problem. There's no such thing as too many routers.

Rod

Re: Plunge router

#5

Re: Plunge router

Jim Dillon

>I have had the PC 690 plunge base for 10 years and use it a lot. I actually keep it permanently mounted. I also bought the PC fence for it and use that as well. While it doesn't have all the bells and whistles of dedicated units, it works very well IMHO.

Jim

Re: Plunge router

#6

Buy the 890 plunge base

Bill Hylton

>A little-known fact is that the 690 motor will fit into the plunge base made for the newer 890 series motor. The newer base has notches in the casting for the pins that protrude from the 690 motor can. Just pop open the toggle latch on the base, align the pins with the notches, and slide the motor into the base. Works like a charm--just tried it.

I'm remembering the plunge action of 690 series plunge base as being balky, not at all smooth. I'm sure the newer base is most costly, but it's a option.

Bill

Re: Plunge router

#7

pc690 plunge base

del schisler

>i have 5 routers and 3 router tables And have pc690 plunge bases These work very well with any plunge project i came across del

Re: Plunge router

#8

Re: Plunge router

Tom O'Connor

>I just finished a large project which required a Lot of plunge routing. My 690 with a plunge base worked great. With a little silicone spray it works soothe as silk.