Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

grizzly dado reviews?

Posts

grizzly dado reviews?

#1

grizzly dado reviews?

mike kula

>I was checking out the Grizzly summer sale catalogue and wondered if anyone out there had experience with their dado sets? They seem decently priced, but wondeering about quality, etc... Anyone used 'em? Thanks.

Re: grizzly dado reviews?

#2

WHich Grizzly dado set? Tehy offer several.

Forrest Addy

>I looked closely at dado sets when I was up at Grizzly's Bellingham showroom. Since I already have a good dado head I didn't buy any of theirs. They sell maybe 6 different sets ranging from a basic set to a very nice one costing over $200. I gave them all a good look judging by eye the angles and clearances of the teeth, the edge finish, the plates and the size of the carbide, overall appearance, and finish, etc and concluded, Asian origin aside, the Grizzly dado sets appeared to offer bang for the buck and to be worth a try for any home woodworker.

Many times I've responded to "how good is thi..." saw blade/daoo set, router bit what ever and I've always responded with an unequivocal "It depends." Even the best manufacturers slip in a production run and a marginal product hits the consumer. This is especially the case with edged tools where performance can be subjective.

A dado set is no better than the cutting edges of its teeth and how the plates fit the saw arbor.

The cutting edges are no better than the hazards they face in the shop. Particles of iron from the hammer mill lodge in the particle board or MDF and sand can be imbedded in rough lumber, staples, etc but all that is obvious. I mention it because you might be unlucky in the first cut and ding a dado set affecting the finish it produces thereafter much to your irritation.

How do you like your dado set ground? Some like the plates to be a trifle proud of the chippers to preclude corner interferance with the mating piece. Some do not. Regardless a purchaser will be vexed when the dado set he buys isn't ground to his preference and there are several popular preferences.

A thin chipper can drop in the thread space a trifle and affect its concentricity. Some don't remember to install the thinner chippers next to the plate abutting the arbor where the arbor is a solid diameter and place the thicker chippers to the nut side.

So there are variables to consider in "the best". A dado set that cross cuts material with thin brittle veneers, leaves a flat smooth cut in the sides and bottom, and fits my saw arbor with out the chippers falling in the threads has my vote for a good dado set.

In days of yore I bought a cheapo dado set from one of those truck sales. The edges were ugly looking but there was plenty of carbide to work with. So I had my saw guy work them over, spending - was it $36? - too long ago. When he was done, that $9.95 dado set performed as well as my $249 Diston stacked set in terms of cut quality. So go figure. I gave the dado set to a contractor buddy, the Diston has long ago been sharpened down to nothing, and now I'm using a Freud stacked dado set. Even with that excellent Feaud set in a fitted case under my extention table what do I use most of the time now? A cheapo Craftsman wobble dado I got for Christmas. What can I say? It's convenient.

That experience leads me to conclude the best dado set or the cheapest perform equally well if they are sharpened properly. That initial sharpening job lasts as long as they stay sharp. As soon as they dull the quality of the set depends on your saw "filer" (the dude that acually puts grinding wheel to the carbide) and no other.

So the best is a perishable perception for an edged tool subject to wear, shop hazards, and its next sharpening job.