Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Grid Extension wing question?

Posts

Grid Extension wing question?

#1

Grid Extension wing question?

Barry Irby

>Thanks to a friendly post down below, I am now the proud owner of a Biesemeyer Fence. I put it on my old Rockwell Delta table saw. That went well but I have realized the saw has aluminum grid extension wings. I am thinking of covering them with plastic laminate (Formica). (The fence slides on the table at the "far" end.)

Any Ideas? What glue would you use to fasten the laminate to the ribs of the aluminum.

Re: Grid Extension wing question?

#2

Re: Grid Extension wing question?

Patrick Schupbach

>I would replace the grid with an extension table. You could put a router in it and get double duty.

Re: Grid Extension wing question?

#3

Re: Grid Extension wing question?

Kent in Emmaus, PA

>Barry, the gridded wings won't give you much surface area for adhesive. I'm thinking epoxy would be the best bet for a strong bond, but if it doesn't work, it'll be a nasty mess to try and remove it.

As an alternative, I'd say build a laminate covered wing, like Patrick suggested. Or, you can attach a foot to the underside of the fence that rides on the rear rail. Biesemeyer used to make a "Sears version" that did exactly that.

Re: Grid Extension wing question?

#4

Good catch!

Mark Goodall - ATL - tooljunkie

>You got that Bies at the Lowes. Very good deal!

If you try to laminate something on those wings, it will raise the surface. Is there enough adjustment room in the mounting between the wings and the saw top to lower the wings relative to the tabletop so that the top of the laminate will be flush with the saw's top? Just wondering.

Otherwise you could do this (shudder) put laminate across the whole saw. I've seen it several times at cabinate shops.

Happy Woodworking!

Re: Grid Extension wing question?

#5

Re: Grid Extension wing question?

john lucas

>I will agree with the extension table. To get a really good bond with the plastic laminate you would have to fill the gaps in the metal extension. I would go with the wooden extension. I'd make it a torsion box and ideally put the router in it.

Contact cement will hold the formica to the metal quite well if you decide to do that.