Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

3.4in Plywood

Posts

3.4in Plywood

#1

3.4in Plywood

jason wojnar

>Hello,

I read and lost the magazine that had a router bit size for making dados in 3/4in plywood. The article said that most 3/4 plywood is not 3/4 but ???? and if you use a 3/4 bit, the dado will be to big for the 3/4in plywood. Can any one help with what size router bit I should use????

Thank you,

Jason Wojnar

jason.wojnar@us.army.mil

Re: 3.4in Plywood

#2

JL

Re: 23/32"...

JL

>usually does it for me. Eagle, MLCS and others carry them.

Re: 3.4in Plywood

#3

Re: 23/32"...

john lucas

>I bought a set of 3 from one of the company's. They simply called them Plywood bits.

Re: 3.4in Plywood

#4

Re: 3.4in Plywood

Lee Ohmart

>I got the 23/32 bit from Whiteside. The dadoes were nice and tight for the bookshelves we built and it stayed sharp throughout the project.

Re: 3.4in Plywood

#5

Re: 3.4in Plywood

Jim Dillon

>Jason,

While your quest for the perfect fit is laudable, keep in mind that your piece of plywood may vary just a bit in thickness along its length and width - especially near uncut edges. Maybe it is a moisture thing or something. If I can afford the loss in wood, I usually cut an inch (couple of centimeters) off the edge and go from there. And a longer piece of plywood may be bent a bit making the fit all along the "perfect" dado more troublesome. On the other hand, if you are just cutting dadoes for bookshelves etc, then the 23/32 inch bit mentioned by others may be what you need, but I've never had much luck with it; it ends up being too small or too big. Using good quality plywood will also make your job easier. Just some thoughts. Good luck.

Jim

Re: 3.4in Plywood

#6

Re: this can of worms (long)

Peter Hyde

>Glad to see someone open this can of worms.

Up here in the cold north we are metric (or at least supposed to be ) Now since this has been forced on us there has been no guarantee just how thick a sheet of plywood will be. Working in a commercial environment you can imagine how this really screws up your day! We have fought and argued with all our suppliers and even changed some, but the fact remains "the industry standard" is anything within 1.5 mm is considered acceptable. The big P.O. is that even sheets within a lift can vary this amount and even the sheet itself can have as much as 1 mm. variance. So we went looking at Baltic Birch figuring the Europeans would know what metric is. Although the sheets are certainly a lot more uniform in thickness they do vary by as much as 1 mm from different suppliers, so there really isn't much to choose between the 2 sources. We always check the packaging on the lifts to see where the stuff is made. Baltic Birch seems to be all made in Russia ans everything else seems to be Asian in origin. Mow this is here in the Great White North so your experiences may vary.

I am so pleased to be retired now and not have to fight with this issue any more.

Re: 3.4in Plywood

#7

I hear you!

Jim Dillon

>Peter,

So it is not (necessarily) my lousy woodworking technique? 8-) I can't count the number of times I have carefully sized a groove in a door stile/rail based on a small sample of the piece of plywood I intended to use, and then the final piece wouldn't fit into the groove or was too loose. Thanks for letting me know that it might not be entirely my fault!

Jim