Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

tongue and grove

Posts

tongue and grove

#1

tongue and grove

Danny- Hermann,MO

>I'm making cabinets for the garage with mission style doors. The center of the doors are 1/4 oak plywood. Can anyone tell me if there is a formula for how much undersize to cut the plywood? The size of the panel for an exact fit wood be 7 3/8 x 13 1/4. Thanks for any help and suggestions!

Danny

Re: tongue and grove

#2

Re: tongue and grove

Barry Irby

>If the panels are plywood, you can cut them exact and glue them into the grooves if that suits you. The movement in the plywood would be so slight at that relatively small size that it would match the movement in the frames. If you do this, you can rely on the panels for some contribution to the strength of the doors and not have to add Mortise and Tenon joints to the styles and rails. The T&G would be strong enough. I would cut all the pieces and dry fit them to be sure the joints pulled up tight and then glue and assemble them.

Re: tongue and grove

#3

Re: tongue and grove

Jim Dillon

>Danny,

I agree with Barry except I would probably make the plywood panel just a tad undersize to compensate for any screw-up in the depth of the groove for the plywood and to better allow the stile and rail joints to come together during glue-up. As Barry said, be sure to do a dry-fit first to check all joint interfaces for good contact. And be sure to keep the entire assembly very flat during glue-up to eliminate any twisting etc. and DAMHIKT. You will have a mighty strong door when you are done and an easy one to make. Good luck.

Jim

Re: tongue and grove

#4

And note that 1/4" ply isn't quite 1/4"...NM

Grant Smith

>

Re: tongue and grove

#5

Re: tongue and grove

Charles Sharp

>I purchased a 3 piece set of Harbor Freight door router bits several years ago. They cut a simple radius on the front side and a square sholder on the back. If I were doing what you are, I would take them apart and reassemble them so the the square sholder would be on the outside. For $39 they arn't a bad set of bits.