Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Swelling TS outfeed table

Posts

Swelling TS outfeed table

#1

Swelling TS outfeed table

Dustmaker Mike

>well I set up the TS yesterday after I hooked up the ice maker to the fridge. Seems when my brother unhooked the ice maker he turned the valvue off but there must have been a little nick in the rubber stopper. Cause for the last three weeks it has been dripping unseen in my basement. My outfeed table to my TS was sitting in the floor and it did a Great job of soaking up the water. it swelled the center part where the blade guard comes though so now it sit proud of the saw to b y an 1/8th inch or so. I am hoping it will shrink back to normal size but i doubt it.

My saw is a Uni with Delta factory outfeed table do I stand a chance or should I just build another piece when I get a chance?

Re: Swelling TS outfeed table

#2

Re: Swelling TS outfeed table

Kneale Brownson in sunny N. MI

>Doesn't that table have some pressboard substrate? Swelling will never go back to flat, I believe.

Re: Swelling TS outfeed table

#3

I hate flush outfeed tables.

Forrest Addy

>I hate flush outfeed tables. I have mine arranged 2" below the table surface at the saw table edge rising to flush about 6 feet out. I can attach or detach them in a few seconds (they drop in place on a special horse I made for the saw.)

My outfeed table looks remarkably like three old hollow closet doors drilled at the top edge for a couple of pins that fit a bracket on my saw table. They normally lean against the wall by the saw. Sometimes in a fit of tidiness I'll put them in the plywood rack.

I can push work through and once it's past the table it drops allowing several repeat cuts to stack up before it's necessary to handle them. This is a real advantage when you work a lot in thin plywood.

Having the outfeed table easily portable greatly reduced the acreage of the "flight deck" in the middle of the shop giving the worker more space for other things.

Anyway, soggy table won't last any longer than the water. Dry them out without haste or heat and they should come back to size. If not run them through the TimeSaver. WHAT!! You haven't got a wide belt sander? Here's a perfect excuse!

Re: Swelling TS outfeed table

#4

Re: Swelling TS outfeed table

Larry Clinton At Frankfort (Central)., Indiana

>My Uni outfeed table (stock Delta table) is either MDF or particle board with a formica top. I feel sure if yours has swelled due to water, it won't return to size. I would be looking for a nice piece of grey formica. I think I saw some plain grey at one of the borgs - believe it was Lowes. Can't remember what I put on my router table, I think it was pretty close to the Delta color, know I bought it at either Lowes or Menards three or four years ago. I know that if I replace my Uni table I will use Baltic birch with formica on both sides. My Uni table has a cracked 2x2 under the outfeed table where it attaches to the main table. It has allowed the back edge of the table to drop a 1/16 or so, repairing it is on my round tuit list. I think the top is ok so won't have to replace it at this time.

Re: Swelling TS outfeed table

#5

Re: Swelling TS outfeed table

Jesse in New Mexico

>Sounds like its time for a new outfeed table. I would recommend as big a table as you can fit in your space. I use mine for outfeed, sanding, assembly, etc. etc. Best tool in the shop!