Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

So, I got tired of doing ductwork...

Posts

So, I got tired of doing ductwork...

#1

JL

So, I got tired of doing ductwork...

JL

>maybe it was all the trips up and down the ladder.


img

Re: So, I got tired of doing ductwork...

#2

JL

Re: and decided to finally install...

JL

>the track lighting.


img

Re: So, I got tired of doing ductwork...

#3

Re: and decided to finally install...

calvin in Irmo, SC

>JL,

Good deal. How about a picture of your under lathe cabinet for those of us thinking about something similar. Thanks.

Re: So, I got tired of doing ductwork...

#4

JL

Re: Here it is... *LINK*

JL

>I took Dominic's idea for a ballast box and lowered it. I then mounted a drawer unit on top of the ballast box. I've got a couple hundred lbs of sand and gravel in bags in the ballast portion.


img

Dominic's Ballast box article

Re: So, I got tired of doing ductwork...

#5

Hey JL,.

George@Colonel's Workshop-Havertown PA

>Good Afternoon JL,

I've toyed with that idea every time I vacuum the lathe room. The dust port looks like it may be a little small for the amount of dust and chips which will stream off your lathe while in use. Any problems with its size? I was thinnking of installing a larger hood.

George

Re: So, I got tired of doing ductwork...

#6

JL

Re: Hey Colonel...

JL

>That all depends what you are turning. They do make larger hoods.

The main reason I have this particular hood is sanding dust from spindles (it will work for bowls also), not chips. I don't breathe chips. I don't mind sweeping chips. Dust gets everywhere.

Also, it will work quite nicely at the end of my workbench. I can disconnect it from the duct by the lathe and move it over to the bench. The narrow opening gives a nice flow across the workbench surface.