Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

OT: thinset not sticking

Posts

OT: thinset not sticking

#1

OT: thinset not sticking

Pat Evans

>I just installed 1/2" Hardiboard fastened with ringshank nails per the manufacturer's recommendation as underlayment for a sheet vinyl floor. All nails were carefully set no more than 1/16" below the surface, again per the mfgr's recommendation. I used Henry 547 patch on the nails and joints. However, during a light sanding to remove ridges, the patch came out of almost every nail hole. The floor was carefully vacuumed twice before applying the patch. Any suggestions on how to remedy this would be greatly appreciated. I'm up against a Wednesday deadline to get this bathroom finished.

Re: OT: thinset not sticking

#2

Re: OT: thinset not sticking

Gary Evans Tallassee, TN

>Hi Pat,

How about using the household version of Bondo? I don't know about the cost for your installation, but you can't beat the cure time and the stick-to-itiveness. I would think you could finish it with a putty knife so that you wouldn't see it under vinyl. I know it will stick well to hardboard, as that's how I sealed the vertical seams in my shower.

Good luck,

Gary

Re: OT: thinset not sticking

#3

Make that Hardiboard instead of hardboard.

Gary Evans Tallassee, TN

>