Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Bench dog hole placement question?

Posts

Bench dog hole placement question?

#1

Bench dog hole placement question?

Alan Tolchinsky

>Hi All, I have a small bench that's about 24"x 48" and I'm putting some dog holes in it. I'll be using these with some Veritas brass dogs and their dog clamp that you screw in to clamp the piece.

Anyway how close should I place the holes to the front of the bench? I'm not talking about spacing of the holes but the distance of the line of holes to the front of the bench. It seems like the closer to the front the easier reach you'd have to work on something. Any ideas? Thanks!

Re: Bench dog hole placement question?

#2

Re: Bench dog hole placement question?

George@Colonel's Workshop-Havertown PA

>Good Afternoon Alan,

My bench is roughly 130 years old and the square dog holes seem content at being 1 1/4 inches from the front of the maple work slab. I do have two drawers in the frame and when these are fully closed, the dogs clear the drawer fronts. Remember to consider clearences for anything you may have beneath the bench top.

George

Re: Bench dog hole placement question?

#3

Re: Bench dog hole placement question?

Alan Tolchinsky

>Thank you George, Wow 130 years! With all that history that must be a cool bench. The dog hole placement makes sense to me as you wouldn't have to stretch too far over the bench to work. Thanks again. Alan

Re: Bench dog hole placement question?

#4

Re: Bench dog hole placement question?

Carol - Strawberry, AZ

>If you have a dog in your bench vise, the bench holes are best in line with that. :)

Re: Bench dog hole placement question?

#5

Re: Bench dog hole placement question?

Clint Searl, at the base of Haycock Mtn

>I just drill a hole when and where needed for a particular job. After a while there are enough holes scattered around to accommodate most any need.

Clint

Re: Bench dog hole placement question?

#6

Re: Bench dog hole placement question?

Ray Binnicker

>Good morning George,

Are you the original owner? (:-)

Ray Binnicker

Re: Bench dog hole placement question?

#7

Laughing Out Loud, Ray!

George@Colonel's Workshop-Havertown PA

>Laughing Out Loud, Ray. That was a good one.

I'll tell the story of my bench again. I recall doing so on Badger Pond, some years ago. The bench was a piece of luch and its story is worth repeating.

George