Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Lumber storage support spacing?

Posts

Lumber storage support spacing?

#1

JL

Lumber storage support spacing?

JL

>I'm currently designing the last portions of my shop - lumber storage.

I typically get 4/4, 5/4 and 8/4 lumber in usual lengths of 10-12'. I do have some smaller pieces of course.

So - the big question - how far apart to put up the support brackets? And how many?

I have a nice section of straight cinder block wall. My 8" jointer is currently on that wall, but I have ample space above it.

I was thinking of 4-5 vertical supports. If I do four, they will be at 0', 2.5', 6' and 9'. If I do five, they will be at 0', 2.5', 5', 7.5' and 10'. This would give me a maximum of 1.5' unsupported off of the ends and a maximum of 3.5' between supports.

So - four or five? Or should I consider more?

Re: Lumber storage support spacing?

#2

Re: Lumber storage support spacing?

Kneale Brownson in sunny N. MI

>Will your lumber be on edge or flat? If flat, 40 inch spans are too great, I'd think. If on edge, I'd expect it to be ok.

Re: Lumber storage support spacing?

#3

Re: Lumber storage support spacing?

JKJ in East TN

>Based on past esperience, I personally wouldn't hesitate to use 30" between supports.

If you do need to store a lot of thin stuff, you might do what I did once - I had about 36" between supports so I placed a couple of roughcut 6/4 pieces of red oak down first (in long-term storage) as a "shelf", then put the thinner on top. Everything stayed flat.

JKJ

Re: Lumber storage support spacing?

#4

Bart Goldberg

Re: Lumber storage support spacing?

Bart Goldberg

>I just installed a lumber storage rack system in my garage. The recommended spacing is that the supports should be no more than 3 feet apart. Since I was installing them onto a stud wall, I installed the standards on every other stud (32" apart).

Bart

Re: Lumber storage support spacing?

#5

what will work based on 30 years of experience

Bill Tindall, E.TN

>Our racks had horizontal supports every 4 feet for a total of 4. The last support was 2' from the back wall. They were like a series of "H's" except with more horizontal pieces than the one in an H. This arrangement accommodated lumber up to 14' long handily and when pressed we put 16' lumber in it. These supports were yellow pine 2 x 4 with a span of 44". The spacing between supports was such to hold 500 bdft of 12' lumber. If not clear request that I post a picture.

Re: Lumber storage support spacing?

#6

based on little experience

Jim in Houston

>Well, I store my rough timber in my storage shed, and as I figured brackets hung from 2x4's made from 2x lumber and plywood were WAY cheaper than than the hardwoods I stored there, I put a bracket every sixteen inches. Now to me the primary thing here is how coplanar the brackets are. They must be completely level and co-planar. I used a jig to drill the holes and they came out pretty close. Store flat is the key no matter what the thickness.