My replies (a bit long, sorry)
marc rosen
>Hello All,
I need to thank all of you for your compliments on my bed. I never expected all of these favorable comments and seeing them after a less than great day at work really made me feel alive again. Thanks!
I want to respond the questions below in one message so I hope that is the way to go in this forum.
To Jim; I cut all of the rail mortises (3/4 x 3/8) with a benchtop hollow chisel mortiser and the mortises in the posts were 1/2 x 3. I approached this with a lot of trepidation after laying out the centerline of each mortise but after cutting the first rail the rest seemed very easy. I would be very willing to do this again- the only difficult part was extending a support table for the ends of the boards.The slats were mass produced and I used a router table to cut their tenons. A 3/4 inch roundover bit was used for the tops and bottoms of the rails and the flutes in the posts and side rails were cut with a 3/4 cove bit (not to full depth)
To JL; I ran the 3/4 inch dowel up from the bottom edge of the rails to present cross grain for the screws. (suggested in the orig. plans)
To Lee; Yes, it is a queen size mattress and though I have more mattress slats than in the picture I am thinking about adding a center support. Probably from some of the extra leftover cherry.
Thanks for the precautionary warning.
To Mark; I got the inspiration from an old issue of Woodsmith Dec 1996, but I did not use their techniques to build it. They made their mortises by cutting dadoes in two halves of the rails and sandwiching them together. Also, they used glued up boards where I preferred to use whole boards, and their head and foot board had a cap and base to trap the slats inside the mortises. I did follow their lead for sizing some components but their frame looks vastly different than mine. I'd be happy to scan or copy them for you - or anyone else - if you want it, just send me an email.
To Martin; I picked up the 16/4 cherry at Hearne Hardwoods in Oxford PA. When I got the lumber home I made a cup of coffee and just stared at that 16/4 beam on my back deck trying to think how am I going to crosscut this monster.
And to Joanne;
Thanks too for your comments about Paula and I sharing the work. She was a major factor in the entire project(picking out the lumber and keeping me well fed). I told her that this is the only time I will "make " the bed. That's one "chore" that I never do.
I'm hoping to get the night stands finished by September so I'll post some pics of them as soon as I take them and learn how to size them properly for this site. Thanks once more for making my day a lot brighter.
Marc (Aix sponsa)