Table Top Thickness
Jeffrey D. Rose
>I am not near any of my design resources and trying to figure out how thick most people make their kitchen table tops?
TIA
Jeff in Iowa.
Knowledge You Can Build On — Est. 1998
Table Top Thickness
Jeffrey D. Rose
>I am not near any of my design resources and trying to figure out how thick most people make their kitchen table tops?
TIA
Jeff in Iowa.
Thicker the stronger; thinner the lighter
Forrest Addy
>Thicker the stronger; thinner the lighter but 3/4" seems to be about right for most dining and furniture tables.
I prefer 7/8" because my eye is jaded with ubiquity of 3/4". 7/8 seems to me so robust a thinkness without seeming clunky or heavy. It's a perception thing I couldn't help mentioning.
Re: Thicker the stronger; thinner the lighter
George@Colonel's Workshop-Havertown PA
>Good Afternoon Jeffrey,
I think 7/8" looks better, and I do agree with Forrest. An extra 1/8" thickness over 3/4" allows more choices and room for edge treatments. Besides, a 7/8" board is quicker to thickness plane from 4/4 stock. I shoot for 7/8" thickness in my cabinet/furniture tops also.
George
7/8" is a man's man thickness to be sure
Mark McC
>
depends on the design of the table
Bill Tindall, E.TN
>and the size of the table and probably other factors I can't think of. In most cases anything less than 7/8 to 1" looks skimpy in most designs (5/4 lumber), but for a Trestle table more than an inch would be necessary.
Bottom line, accurately draw a side profile to scale and see how different thickness look.
Re: depends on the design of the table
Bill White
>Built a farmhouse style table several yrs. back. 1 1/4" top w/ heavy looking legs. Came out well.
Bill
I Once Had A Neighbor
George@Colonel's Workshop-Havertown PA
>Whose daughter resembled that table's top and legs. I think her name was Clementine.
George
I made a pine kitchen table for our use
Don henthorn
>with 1 1/2" thick top. It had thick legs so it looked OK.

Was this neighbor...
Ellis Walentine
>...a miner? 49'er?
Re: Table Top Thickness
DB
>If you want a stronger table top without it looking to thick just taper the outside bottom face back about 2-3" down to about 7/8". Could also taper the top face too.
It all depends on what look you want. Where I used to work we would routinely make the edge 1-1/2" thick by building up the edge of the sheet good with a 3/4" build up of particle board and band the edge with veneer.
I bet her Daddy was.
Gary Evans Tallassee, TN
>