Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

Which mortising machine to buy

Posts

Which mortising machine to buy

#1

Which mortising machine to buy

Tim Johnson

>I am getting ready to buy a mortising machine and wondered if any of you had feedback on either the Steel city (model 25200) or delta (model 14-651) machines.

Thanks in advance

Tim

Re: Which mortising machine to buy

#2

Re: Mortizer *LINK*

Mark Mandell - Gone Round In Jersey

>There's a Powermatic for sale in the WC classifieds. Sounds like a very good deal.


For Sale

Re: Which mortising machine to buy

#3

Re: Which mortising machine to buy

Lee Ohmart

>I bought the General model that can be tipped to the side. The chisels were rough but the machine is solid.

Re: Which mortising machine to buy

#4

Re: Which mortising machine to buy

Mike Fitterling

>Most of the small benchtop models are serviceable. But all of them perform much better with the addition of an XY Vise. Check the "Articles" section for the how-to.

Re: Which mortising machine to buy

#5

Re: Which mortising machine to buy

Mark Harrison - Brisbane, Australia

>That's arguable. I bought a Powermatic PM701. I really don't think an X-Y vise would improve it appreciably.

Re: Which mortising machine to buy

#6

Re: Mortizer

Larry Clinton At Frankfort (Central)., Indiana

>I have the Fisch 3/4 hp, 1725 rpm model. It came with the Guidepoint chisel / bit set. I have been very well satisfied with the unit.

Re: Which mortising machine to buy

#7

Re: Which mortising machine to buy

Mike Fitterling

>I think you'd be surprised, but to each his or her own. I'm not an "arguing" man. :)

Re: Which mortising machine to buy

#8

2nd the xy vise

George@Colonel's Workshop-Havertown PA

>Good Evening Tim

I bought the Shop Fox 3/4 hp mortiser and replaced the fence/clamping arrangement with a modified xy vise from Harbor Freight. Its a wonderful arrangement, easy to traverse the stock through the layout lines beneath the chisel, and keep it all in alignment. In my opinion, its the way to go. Some of the higher end tools come equipped with a similar feature. I am perfectly satisfied with my less expensive alternative.

George