The endless project is done!
Steve Kreitler
>Doesn't look that hard, does it? And, really, it wasn't- once I got to the point that I could start cutting the wood.
The problem here is the customer's choice of wood. I tried to talk him into letting me use some old growth pine 1x12's that I've been looking to use, but he insisted on using local mesquite.
The mesquite is where the troubles began. The man who mills and sells it here locally (Abilene, Texas) doesn't follow any of the proper drying procedures- he literally just saws it and piles it on the bare ground out in the weather- not even stickered!
When I got the stuff it was checked and sprung along the grain- I had to fill all of these gaping voids with epoxy (it shows as the larger black lines in the pics). Luckily, I had just stocked up on bulk epoxy for my efforts in building post office box banks from Corian- I used about a third of my half-gallon supply on this, and it seemed to take forever.
None of the boards were wide enough for the sides, so I eventually resawed one, and bookmatched, glueing the pieces to some 1/2" birch ply in hopes of stalizing and strengthening it. The bottom is 3/4" ply edged with mesquite, and the top is a solid mesquite board, with a 2" wide strip of 1/2" birch dadoed into it to support the handle.
Two coats of danish oil, followed by two coats of paste wax, and the guts installed. The customer was happy, even though I cautioned him that I can't guarantee the job with this wood.



