Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

You don't have to be a gorilla...

Posts

You don't have to be a gorilla...

#1

JL

You don't have to be a gorilla...

JL

>A while back I had asked advice about routing a table top with a large (2+" bit). Here is the top after routing the edge. I took the off-cuts from the top and used them to balance the router. It worked very well. Now if I can only learn how to take pictures :).


img

Re: You don't have to be a gorilla...

#2

Re: You don't have to be a gorilla...

George@Colonel's Workshop-Havertown PA

>Good Afternoon JL,

I figured you would have no problem if you did it in increments and used a variable speed router. How much of a bite did you take on each pass abd what speed seemed best?

George

Re: You don't have to be a gorilla...

#3

JL

Re: You don't have to be a gorilla...

JL

>I used a speed of maybe 12,500 or so. As far as the amount of bite, I guess I took off at most 1/4" at a time. The only area that gave me any problem were the back corners as I was transitioning into a flat surface. I actually took off a little of the back, so I had to balance that on the other side.

Here is the bit in question.


img