Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Saw drill bits or screw slot router bits...

Posts

Saw drill bits or screw slot router bits...

#1

JL

Saw drill bits or screw slot router bits...

JL

>Wondering how ya'll cut your slots. I suppose you could also take a Forstner bit and drill several hole and then even them up with a chisel.

So - I have a project where I'd like to cut a number of slots. My current mode is using a 1/4" router bit to cut the slot. This works, but leaves the screw exposed. So, I saw the screw slot router bits in the catalog and was thinking about buying one. I could also buy a saw drill bit - I've use the 1/8" ones to drill and cut fiberglass before.

TIA.

Re: Saw drill bits or screw slot router bits...

#2

Re: Saw drill bits or screw slot router bits...

Ron Hildreth, Alta, Iowa

>JL,

I bought one of Woodcraft's screw slot cutter router bits, and it worked good until I got into a big hurry to meet a deadline. It was completely my fault, as I knew it was getting dull. But you know-"One more short slot and I'm done!" I broke the top off- it's now good to use for counter sinking in the drill press!

I should order another, and will. They do work good. This time I'll take the time to sharpen it when it gets dull---DUH!

Ron in Iowa

Re: Saw drill bits or screw slot router bits...

#3

JL

Re: Saw drill bits or screw slot router bits...

JL

>Well, I was planning on ordering from Eagle or MLCS rather than Woodcraft - I've got a need for a couple more bits. That way I'll get the discount.

Re: Saw drill bits or screw slot router bits...

#4

Don't blame ya there!

Ron Hildreth, Alta, Iowa

>

Re: Saw drill bits or screw slot router bits...

#5

Re: Saw drill bits or screw slot router bits...

Larry Marker in Alabama

>I use a straight bit to cut the slot and then the screw slot bit to make th eround hole and undercut the slot for the head. Using the straight bit to hog out the basic slot will make life a lot easier for the screw-slot bit.

Larry