Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Drilling hole

Posts

Drilling hole

#1

Drilling hole

bhenr99

>I need to drill a 2 3/8" x 1/4" deep hole in a 3/4 stock. The problem I'm having using a forstner of that size is the edge of the hole is rough and not cut clean.The rim of the hole is chipped. Any suggestions? Thanks for any help.

Bob

Re: Drilling hole

#2

Plexiglass and router

Mark Goodall - ATL - tooljunkie

>I would cut out a template in plexiglass, then use a router and a template bit and cut the hole with that.

Happy Woodworking!

Re: Drilling hole

#3

Re: Plexiglass and router

john lucas

>I would do the same but I'd probably use 3/8" plywood.

Re: Drilling hole

#4

Re: Drilling hole

Al Stokka - Cambridge, Iowa

>Bob,

Clamp a piece of scrap on top of your workpiece, then drill the hole through the scrap and the workpiece. Should stop the ragged cut. Well, it won't stop the raggedness but, it will put it on the scrap rather than your project.

Al

Re: Drilling hole

#5

Re: Drilling hole

Marv

>From your description, sounds like you are counterboring a stepped hole in 3/4" stock. I guess the problem you are having is at the top edge? Are you using a drillpress or are you using a drill motor? If you are using a drillpress, for a counterbore that big you need to adjust the speed of the cutter according to the material you are cutting. Are you cutting wood or plastic? If you are cutting wood, the speed should be relatively fast. Going too slow will cause the chipping and splintering. If you are using a drill motor, it is going too slow for wood and it's difficult to control the cutter so it cuts evenly....Marv