Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

muffler/filter for vacuum

Posts

muffler/filter for vacuum

#1

muffler/filter for vacuum

Joseph Mulherin

>Someplace I once saw that someone had made a muffler using some PVC piping. Seems to me I remember coming out of the vacuum with 2" and going into 2" ell with 2x3 reducer added on. From ell thee was 3"x15" pipe (with many holes drilled in it(every 2" up and down and 1 1/2" apart horizontal) 90 on top and cap on bottom(not glued). Inside was 1 1/2" many drilled piping with insulation stuffed in. Air passes thru insulation and is muffled before passing out to the 3". Does anyone remember such a homemade part like this. Would like to see one and make it up. My DC is OK but sometimes I do not like to use it for the saw or router.

Re: muffler/filter for vacuum

#2

Re: muffler/filter for vacuum

wes bischel

>Joe,

I sent a PDF of one I found.

Wes

Re: muffler/filter for vacuum

#3

Brian McKearney

Re: muffler/filter for vacuum *LINK*

Brian McKearney

>I'm not sure if you're looking for a muffler for your dust collector or shop vac, but here's an article that I found when I was looking into cutting down the noise for my DC - I haven't tried it yet, so I can't share any experiences: http://billpentz.com/Woodworking/Cyclone/MufflerBelliveau.cfm (see link below).

By the way, if you're looking for a muffler for your shop vac, then I would recommend picking up a Ridgid muffler from Home Depot. They sell them for around $10 and they work really well. I have had one on my Ridgid shop vac for many years now and it works great. My only additional suggestion is that I put an old sock over the muffler and tied it off, as this cuts down on the air blowing out the muffler, which helps to prevent dust storms in the shop when you're vacuuming.

Brian


Muffler Plans

Re: muffler/filter for vacuum

#4

Re: muffler/filter for vacuum

Joseph Mulherin

>Thanks, Brian, I already have seen those plans. I have a DC from Shopsmith and it is a little different from the one shown.

I was seeking some plans for a shop vac only. Saw one that was just an adapter stuffed with steel wool and pushed into the exhaust opening, but I think my idea will be better for what I am seeking.

Re: muffler/filter for vacuum

#5

Re: muffler/filter for vacuum

Joseph Mulherin

>Thanks, Wes, I got the email, but it was listed using PSD, which I do not understand or could find out how to open.

Re: muffler/filter for vacuum

#6

Re: muffler/filter for vacuum

Joseph Mulherin

>Thaks again, Wes, I finally got the picture to print out after I used the Photoshop program. My outlet is on the horizontal rear of the vac, but the idea is just right for what I was seeking.

Re: muffler/filter for vacuum

#7

Re: muffler/filter for vacuum

Joseph Mulherin

>I went to HD and picked up some parts and made the muffler. It works just fine and is not noisy anymore like it used to be. Am going to setup a piping on the wall with 3 Y's and use flex hoses to the equipments I use. Am going to making my own waste gates and have a floor waste gate too.