Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

TS Motor Problem....Please Help...

Posts

TS Motor Problem....Please Help...

#1

TS Motor Problem....Please Help...

Rob Hix - King George, VA

>Hey all,

I was cutting some oak this morning when the wood bound on the blade. It stalled the motor on my Jet contractor saw and threw the breaker on the motor. After resetting the breaker, the motor will start, run a few turns, and then start cycling on and off in short bursts. It then totally quits running. Turn it off and back on and nothing happens. Wait a few minutes, turn it back on and it does the same thing.

Could someone please help me diagnose the problem. I have a deadline on a job and I really need the tablesaw.

Thanks in advnace,

Rob Hix

Re: TS Motor Problem....Please Help...

#2

Dale Lenz

Re: TS Motor Problem....Please Help...

Dale Lenz

>Sorry to hear of your problem. If you don't find a solution I'd pull the motor and get it to a motor shop and have them check it out. Not much help on a Saturday afternoon.

If your saw is going to be out of service for several day, touch base with your customer and explain things. It's best to communicate with your clients, instead of them guessing what going on.

Good luck. Dale

Re: TS Motor Problem....Please Help...

#3

Agree On Both Counts.

George@Colonel's Workshop-Havertown PA

>Hey Bob,

Sorry to read of the problem and wish we were closer. You could do the job on my saw. I also have the 18 amp Jet motor on my saw, and have stalled it only once or twice, and it never misbehaved afterwards. I would definitely gewt it to a motor shop. And explain to the customer.

George

Re: TS Motor Problem....Please Help...

#4

Re: TS Motor Problem....Please Help...

John Parker

>Rob, I am not sure if your motor has a centifigal switch but maybe thats where the problem is. See if you can remove the rear cover off of the motor and take a look. Good luck.

Re: TS Motor Problem....Please Help...

#5

Re: TS Motor Problem....Please Help...

Chuck Lenz

>Did you check to see if the belt had mysteriously jumped off the blade arbor pully ? Or that there isn't another chunk of wood lodged in there somewhere binding it up ?

Re: TS Motor Problem....Please Help...

#6

Been there done that . . .

s.mackay@worldnet.att.net

>more than a few times. 'Bout six. Sounds just the same. Its not that neat little re-set switch. Its the main switch. To check turn the TS over on blocks so the blade clears EVERYTHING ! AND I MEAN EVERYTHING inside and out of the housing. Now by-pass the switch unit by disconnecting the wires and jumping around it. If thats it DO NOT replace it with a light switch or such. I canibalized from a couple other machines in " THe Lot ". IF you've got a multi-meter you can check the swtch with that. Does'nt cost anything just to check it BUT the fault is intermitant so may not show up with an Ohms check. Best is to replace with a " known good " switch.