Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Finishing Shellac With Qualasole - Streaking

Posts

Finishing Shellac With Qualasole - Streaking

#1

Finishing Shellac With Qualasole - Streaking

Steven Pollack in Chicago

>My finishing schedule so far on this bubinga table top:

1) Watco Danish Oil

2) Dewaxed garnet shellac thick enough to seal the pores and then sanded back

3) Qualasole

I wet sanded the shellac back to 1500 but it was all white and powdery. So I figured I needed to french polish but someone suggested Qualasole as an easier alternative. Being new, easy was appealling to me.

As I pad on the Qualasole I am getting a nice glassy surface when looking straight down on the wood without any lights but as soon as a light hits the surface, especially raking light, there is a streaking on the surface. It is more like a residue than the surface not being smooth.

I have tried rubbing the Qualasole hard to rub it out and that did not work. I tried applying it soft to create a single layer but I still get the streaks.

What am I doing wrong?

Steve


img

Re: Finishing Shellac With Qualasole - Streaking

#2

Re: Finishing Shellac With Qualasole - Streaking

Steven Pollack in Chicago

>More raking light.


img

Re: Finishing Shellac With Qualasole - Streaking

#3

Re: Finishing Shellac With Qualasole - Streaking

MikeW

>That was probably me .

A few things.

Your oil may not have been dry (or dry enough).

The sanded out shellac (I simply use 0000 steel wool) should not leave the surface chalky--at least it should not appear so after wiping it down.

The streaking well could have been in the garnet shellac surface and simply brought to light (so to speak) by adding the top coat.

Rags may be contaminated with dust, oil or whatever they were processed with.

The pictures almost look like there is a build-up of something where the streaks are the heaviest. This may well be from too much finish being applied and attempting to rub it out.

If you are using French Polish techniques (MS on a rubber) in combination to the Qualasole, it may not like that. I haven't tried it, so I don't know. But that could trap MS under the finish (Qulasole or Shellac) if too much is used.

Probably more thoughts on this, but I need to get back to work. Hopefully others will have a better idea.

Take care, Mike