Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

vacuum spending the night out

Posts

vacuum spending the night out

#1

vacuum spending the night out

DizD

>I had to recut a part with a 3/4 dovetail groove about 1" long in a block. Since it was just one part, instead of setting up table saw to hog out the center I decided to just cut it with DT bit. Worked fine with a slow feed rate and the shavings were left on router table when I picked up the piece. A few minutes later I happened to notice a black wad with a very red center and smoke curling up from the pile. I'm convinced if I had breathed on it once I could have been ready for marshmallows. Since it was a groove I don't think the vacuum picked up any hot stuff, but I'm leaving it out on the concrete tonight.

DizD who believes in the adage "Learn from others mistakes cause you won't live long enough to make them all yourself."