Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

router bits

Posts

router bits

#1

router bits

Danny- Hermann,MO

>I was wanting some opinions on router bits for making mission stile doors for my cabinets. Basically looking for the tongue and grove bits. Up to this point in my wood woking, I've been using Woodline bits. The more I use them, for whatever I'm doing, the more dissatisfied I become with them. The quality just doesn't seem to be what it needs to be. There are several differant ads in magazines, one is Amana Tool and the other is Whiteside.

Any suggestions or comments are greatly appreciated.

Thanks

Danny

Re: router bits

#2

Re: router bits

Thomas S Stockton

>Amana and Whitesides seem to be equal quality. You won't be dissapointed by either they are top of the line in quality and pretty moch all I use.

Tom

Re: router bits

#3

Agree. Also Infinity and CMT

George@Colonel's Workshop-Havertown PA

>

Re: router bits

#4

Re: router bits

Larry Clinton At Frankfort (Central)., Indiana

>I have not used Amana bits, but I have used several cheaper bits - Rockler, MLCS, etc. I also have several Frued, Whiteside, Bosch, etc. I have decided based on the cutting results and cutter life, that the only bits I will purchase from now on will be Whiteside, if they are available in the style I need. I just ordered several bits (the 13 they make for the Leigh jig - uses 14 total) for the new (to me) D4 Leigh dovetail jig I just purchased at an auction a couple weeks ago. I have found that Routerbits.com - see under Marketplace on the left have the best prices on Whiteside I have found anywhere. As they are a sponsor of this site, I will purchase all bits I can from them.

Re: router bits

#5

Re: router bits

Jim Dillon

>Danny,

I've had luck with CMT and Whitesides, and also a couple of Lee Valley bits. Good luck.

Jim

Re: router bits

#6

Fine Woodworking ...

Mike Farinella

>in their June issue rates Whiteside # 1 (Best overall and value), and Eagle #2 (Best overall). Lee Valley rated #3.

Re: router bits

#7

Re: router bits

knotscott

>Hard to go wrong with Whitesides. US made, competitively priced...especially thru Holbren.

The Woodlines are decent grade economy Asian made bits much like the MLCS, Woodcraft, Holbren line, Grizzly, etc. My best bits are Whiteside and Infinity, closely followed by Freud and CMT. The CMT cut fine but I find the carbide to be alot thinner than the Whiteside and Infinity.

Re: router bits

#8

Re: router bits

Charles M

>The adjustable Freud set below is a patented design that allows for t&g from 7/32" to 3/8" in increments of 0.002". It also has opposing shear angles on the tongue cutter to eliminate the splintering when cutting across grain:

Charles M

Freud America, Inc.


img