Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

OT Plumbing Question

Posts

OT Plumbing Question

#1

OT Plumbing Question

Nat Robison

>I'm finishing up a new bathroom in the basement and just installed the toilet and sink today.

There is very little cold water pressure at the sink (last fixture on the run). Hot water pressure is great and the refill pressure on the toilet is fine. There's a shower that's first on the run but it's not hooked up yet.

What are the likely causes for this??

Re: OT Plumbing Question

#2

Re: OT Plumbing Question

John Veerkamp

>Try taking off the screen on the spout. Being the end of the line it is quite possible that debris from soldiering has collected at the end of the line and is obstructing the flow. If this doesn't help then there is some restriction further up the line, It's a process of elimination then to find it.

John

Re: OT Plumbing Question

#3

Re: OT Plumbing Question

Mark Nowicki

>Possibly some debris fell into the pipe, got pushed into the cold water cartridge and is restricting the flow. Remove the cartridge and flush it out.

A defective or partially opened shut-off valve (if installed)

A kink in the supply line (if you used the flexible kind)

Regards

Mark

Re: OT Plumbing Question

#4

Re: OT Plumbing Question

Nat Robison

>Thank you, Mark. My dumb-a** just got it fixed. It was a kinked flexi-line that's a bit longer than it needs to be but I put them since I had them on hand. I worked out the kink and the pressure's fine. Thanks again. I hope I would have gotten there eventually.

Re: OT Plumbing Question

#5

You are welcome

Mark Nowicki

>BTDT, better an inch too long that half too short anyway.

Mark

Re: OT Plumbing Question

#6

COULD ASK JOANN OR RUTH

Ken Oakley-Sunny St. Cloud, Fla.

>they have plumbing experience