this is how stupid I have become
Tom Sontag - St. Louis
>Two full days in the shop this weekend. Everything was going pretty well til midday Sunday.
First day, after a quick cleanup and business related shop chore, I resawed some spalted sycamore for a new box. This board had a couple of long meandering black lines that made a very unique and interesting pattern along its length. When you resaw such a board you have a bookmatch which goes from side to side or end to end. Matching end for end means that it is possible to line up the four sides with an unbroken black spalt line going around the box, all four corners showing an unbroken design. I spent the first day preparing these boards with trim on each edge and laminating up the bottom with shop cut cherry veneer.
Next day clean up the trimmed sides, thickness exactly in the drum sander, cut groove for bottom, install shelf runners for trays that set in box, etc. Ready to finally cut the 2 pieces into four and glue it up.
The two side pieces get cut in roughly a one third/two thirds ratio, the box being longer than it is wide. So I set the two pieces end to end and visualize where to cut. Move boards one further in front of me than the other and draw my line on each with chalk. Miter the boards to length. Dry fit to check the fit of the bottom and miters. Examine. Attempt to see unbroken meandering spalt line despite clamps which hide a portion of the corner. That's okay cuz this corner's just right. And so is...WHAT?! No matchee! The next one's fine, the fourth a bust! I must have cut the side boards wrong and got uncomplementary "L" shapes or something!
Sit down. Breathe. Figure out what happened.
Must have flipped something (physically or mentally) when I moved the boards around for marking. If I only end up with two matching corners, the whole beauty of the piece is ruined! Relax. After a while I accept fate and decide to complete it as is. The wood is awesome enough to not abandon it. Walk away for a bit and do some yard work. Come back.
Do more fitting and sanding and other stuff and dry fit it again (this is maybe two hours later). Hey, wait a second. All four corners match! What the...?
Sit down. Breathe. Figure out what happened.
I obviously cut the sides correctly after all and simply had the ends reversed on the first dry fit. The upper spalt line on two corners matched up by coincidence and made me think I had the correct fit, the lower spalt line being covered by clamp faces.
Okay, the story has a happy ending since the box is glued and in clamps and looking according to plan. But those two hours of defeat I suffered soley because I could not think of exchanging end pieces will weigh on me for some time. Perhaps more so since I approach one of those milestone birthdays.
Hope you enjoyed your weekend.
Fresh from the clamps:




