Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

small stuff push block

Posts

small stuff push block

#1

small stuff push block

wayland

>I was routing some roundovers on some 3/4" square pieces about 24" long, couldn't use my normal jointer push blocks but didn't want to get my fingers real close to the spinning router bit. So I made special push blocks by stapling some small diameter pipe insulation (1/2" I think) to the edge of a piece of 1/2" plywood about 3x6". I come in at an angle with the insulation pushing the work down and against the router fence and can slide the work along real well.

Send me an email if you want a picture; I don't want to fool around with uploading.

Wayland

Re: small stuff push block

#2

perhaps a wasted post

Bill Tindal, E.TN

>I read with interest your idea for a push stick but couldn't picture it in my mind. I was disappointed that you didn't provide a picture like what is common and expected. If you don't know how to do this easily there are lots of folks here that will help. Your closing sentence almost sounds like we weren't worth your effort.