Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Success in bending thin strips

Posts

Success in bending thin strips

#1

Success in bending thin strips

Bill Tindal, E.TN

>First, thanks to all that pointed to the errors in my ways at trying to bend thin strips and thanks for the pipe suggestion that pointed the way to success.

The canning pot was the correct radius. Under the band clamp is the thin strip. The paper is to prevent transfer of old glue soaked into the band from the band to the wood and it also provided an absorbant for water. The bands were tightened, the web sprayed with water and the whole affair put into a 275 degree F oven for 10 min. After 10 min the web was sprayed again to soak it and the pot returned to the oven for another 10 min. Then the pot was cooled and the strips removed,nicely bent. I made no effort to optimize these times.

Next the oven was raised to 550 to prepare for baking the pizza.

By the way, a hand planed surface does not fuzz up when steamed.


img

Re: Success in bending thin strips

#2

Re: Success in bending thin strips

Don Orr

>Glad to hear it worked out well for you Bill. By the way-watcha makin' ?

Re: Success in bending thin strips

#3

Kitchen light, will post later

Bill Tindal, E.TN

>

Re: Success in bending thin strips

#4

Re: Success in bending thin strips

David C. Lykins - guitardude - Marietta GA?

>Just an FYI if you ever need additional diameters, when they bend musical instrument sides, they're bent with sort of an iron that clamps to your bench, they make a pricey electric iron, but many top luthiers (instrument builders) actually soak the wood in a long tub of water and then just bend it around a steel pipe that's being heated by a propane tourch. You can actually bend one large diameter, or in the case of a guitar side, you make two large bends on each end and one smaller bend in the middle to shape half of a guitar body side.

Here's a picture of the electric bending iron, they're bending the side of a mandolin.


img