Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Glueing drawer bottoms

Posts

Glueing drawer bottoms

#1

Glueing drawer bottoms

Bill Tucker

>Making large plywood drawers (24 X 30 X 10) designed to hold up to 100 lbs and was wondering if glueing the bottoms into the rabbits would make them stronger without expansion/contraction problems? Planning on 3/4" sides with 1/2" bottoms and side mount full extension slides. Any suggestions and advise would be appreciated.

thanks,

bill

Re: Glueing drawer bottoms

#2

Ellis Walentine

Here's what I would do...

Ellis Walentine

>Absolutely glue the bottoms into the sides. Also, don't rabbet the sides; groove them to accept the full thickness of the plywood, and place the grooves at least 1/2" above the bottom edges of your drawer sides. A rabbet offers no mechanical support, so if you rabbet the sides, you would be relying on your glue and/or fasteners to hold the bottom in place -- a losing proposition, or at least a bad compromise.

Expansion and contraction will not be an issue with plywood bottoms.

Ellis Walentine, Host

Re: Glueing drawer bottoms

#3

Re: Here's what I would do...

Bill Tucker

>Thanks for the quick reply - will do. One additional question, do you think the 1/2" ply will be enough for the bottoms, or 3/4" be better.

thanks,

bill

Re: Glueing drawer bottoms

#4

Ellis Walentine

You'll be fine with 1/2"...

Ellis Walentine

>... but 3/4" would also be fine, maybe better depending on the distribution of the load in the drawer. If you go with 3/4" ply for the bottom, rabbet the bottom edge to create a 1/2" tongue all around. Position the groove in the sides as I mentioned before.

Ellis Walentine, Host

Re: Glueing drawer bottoms

#5

Re: Glueing drawer bottoms

Jim Swank

>Dado the sides as Wallace suggests. I'd also dado the front, and insert the back into dados on the side. I'm assuming you'll dovetail the sides to the front. Trim the back off at the top of the bottom, and allow the draw bottom to extend to be flush with the rear edge of the back. Then glue or tack the bottom to the back.

Expansion/contraction is not an issue with the plywood bottom, but might be with solid front sides and back. This method accomodates any movement that occurs, and should easily handle your hundredweight.

Re: Glueing drawer bottoms

#6

Re: Glueing drawer bottoms

Bill Tucker

>Actually going to use ply on all 4 sides with a cherry front added on. No dovetail jig available, so plan on using finger joints front and back. From what I've read, they are tough to set up, but once dialed in, everything goes pretty smoothly - I hope, I hope, I hope!

Thanks for the help.

bill

Re: Glueing drawer bottoms

#7

Re: Glueing drawer bottoms

Clint Searl, at the base of Haycock Mtn

>If you use Baltic birch ply, glued and screwed butt joints will be plenty strong, especially with the bottom glued into grooves front and sides, per Ellis' suggestion. Butt the sides to the front so the screws will be in shear.

Clint