Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

OT.Any replacement window gurus here?

Posts

OT.Any replacement window gurus here?

#1

OT.Any replacement window gurus here?

Virgil

>I have a vinyl replacement window question regarding the caulking on the outside of a replacement unit.The instructions are less than clear and the tech line...well.... On the outside bottom of the window there is a snap in piece that fills the gap between the sill and the base of the replacement window. Should the gap at the bottom be caulked solid along the bottom or should there be a couple 3/8" "weep" (gaps) holes left to let any moisture out that might get behind the window frame? There should not be any water getting back there but someone at work mentioned caulking with a couple small gaps.Most jobs I've "inspected" here in the neighborhood have been wrapped in al. and caulked solid. Thanks

Re: OT.Any replacement window gurus here?

#2

Ellis Walentine

Not a guru, but...

Ellis Walentine

>...I caulked all my replacement windows solid on the outside, and on the inside, I blew Great Stuff urethane foam insulation into the spaces between the sill and jambs and the rough framing. This provides a vapor barrier plus it seals against infiltration and cold.

No problems I can see.

Ellis Walentine, Host

Re: OT.Any replacement window gurus here?

#3

Calk is like clamps, never to much !

s.mackay@worldnet.att.net

>With windows OVER do it. " Weeping " will go INSIDE the walls. Bad thing. You'll also eliminate air movement. Good thing. Now-a-days we pay big bucks for " R " factor. ANY gaps negate it.

Re: OT.Any replacement window gurus here?

#4

I've caulked these things like I've

Virgil

>stole a dozen cases of caulk. Set them into a bead on the stops while installing.Inside before putting the stops back on and outside around the perimeter with a urethane caulk. All that is left is the bottom outside bead.Thanks

Re: OT.Any replacement window gurus here?

#5

Re: Not a guru, but...

Barry Irby

>Be carefull with the Great Stuff. Be sure you use the low expansion or extreme low pressure stuff, whatever they call it. The regular stuff expands with enough force to easily distort a window. If you shoot it up the sides it will push the frame inward enough to jamb the windows and make them inoperable. Or at least it could.

My friend shot it under a bath tub he was installing (thinking it would spread the load and insulate the tub.) It picked the tub up aobut an inch. That was a 300 or 400 pound cast iron tub.

Re: OT.Any replacement window gurus here?

#6

Some good flashing work . . .

s.mackay@worldnet.att.net

>and you should be set up ! Before ya' put it on any gaps you have left fill up with " expand-o-foam ". You'll never worry about it again.