Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Cabinet question

Posts

Cabinet question

#1

JL

Cabinet question

JL

>I finally got some spare time from building sets, so I'm finishing up my last base cabinet for the long wall in my shop.

I'm making an almost 48" wide cabinet out of 3/4" plywood. The top is inset into the rabbeted edges of the sides and back. There is a face frame attached to the front. The bottom is inset into a 3/8" deep dado on the back and sides with the face frame on the front. There is a cut out on the sides where I'm going to eventually put a toe-kick.

Okay - should I support the bottom further by putting a piece of plywood (or lumber) from side to side (parallel to the back)? I've got about 3" to play with.

The cabinet will be used to store various power tools.

Re: Cabinet question

#2

Re: Cabinet question

Charles Sharp

>I would put something underneath the deck of your cabinet to support the center, perhaps a couple of 2 x 3's on edge. Just make sure they don't touch the floor or you may have trouble getting your cabinet level.