Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

finishing question

Posts

finishing question

#1

finishing question

lee beeden

>I have just finished a kitchen cabinet for a friend. There's nothing standard about the house and the same can be said about the cabinet.

I was able to get some incredible Douglas fir for the project and used spalted birch for the panels.

Now these are my thoughts;

This project is just crying to be finished with oil. It would look incredible!! I was thinking about finishing the outside with a wipe on oil finish and then finish the insides, drawers etc, with a brush on water based finish so it doesn't smell. what do u think?

Also i laminated a butcher block top, its one slab of a counter top. Oil would not be a good choice here. What kind of finish could i use that would match the oil on the front of the cabinets?. I'm looking for that warm finish. My past experience finishing a wooden counter top with a water based finish resulted in a kind of dull finish, almost colourless

Many thanks for your feed back

Lee

Re: finishing question

#2

Re: finishing question

Clint Searl, at the base of Haycock Mtn

>This piece includes both spalted Beech and spalted Maple. The finish is gloss nitrocellulose lacquer, rubbed out with 0000 steel wool and Butcher�s Wax. They may be close enough to spalted Birch to give an idea. I think that an oil would tend to dull and flatten the grain and pattern. JMO

Clint


img

Re: finishing question

#3

Re: finishing question

Paul Dwight

>Will this piece get the same kind of use and abuse that kitchen cabinets normally see? If so, a finish like tung oil or Danish oil probably would not provide enough protection from oil, grease, food stains, water, etc.

You could start with the tung oil and, after it's fully cured, apply a topcoat for durability. Substituting a coat of dewaxed shellac in place of the tung oil would give you a similar look without the long cure time of the oil.

For the topcoat, many good products are available. If you're set up to spray finishes, NC lacquer or one of the Target waterborne products would be a good choice. My current favorite topcoat is General Finishes High Performance Polyurethane, a waterbased poly that does very well whether brushed or sprayed. The Satin version of this product is pretty low-luster and might be just what you're looking for -- not too far from an "in the wood" oil finish.

For the butcher block counter top, I'm not clear whether you expect knives to be used on it. If it's going to be used as a cutting board, you will want to avoid any type of film-forming finish. No clear film-forming finish will survive being used on a cutting board without becoming scratched and cut, and once the film is broken and water gets to the wood, the film will break away from the wood and you'll end up with bits of finish in your food. Probably not a health risk, but certainly not appetizing -- and the counter top would look awful, to boot. If it's going to be used as a cutting surface, then it should see an oil finish, only. Lot of folks use mineral oil on cutting boards. Pure tung oil would probably be fine, too, but I would avoid anything that contains metallic driers.

If the countertop isn't going to have knives used on it, then I guess you'd be looking for a film-forming finish similar to what you'd use on a kitchen table. For high-wear surfaces like this, I think you really need a cross-linking finish. Two-part conversion varnish would be great, if you can find it and if you're set up to spray. The best of the modern waterborne finishes are nearly as durable, though, and are much safer and easier to use. Examples would be Fuhr 255 (though this stuff can take weeks to fully cross-link) or one of the Target Emtech products.

Good luck! -- Paul

Re: finishing question

#4

great looking piece.

John Pappas

>