Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

OK here's a tough one.....

Posts

OK here's a tough one.....

#1

OK here's a tough one.....

Ron Bauman

>I'm rebuilding an ancient post turning lathe. I need to have a couple of face plates made. The headstock spindle is threaded, but mashed a bit. I need to get a nut to fit the spindle before I invest in the face plates.(Just to make sure it's the right one) I've found a source for a tap and die. Here it comes: the nut is a right hand thread, 1 3/8" x 8 thd/in. I've gleaned all I can from the internet and found only one supplier; Fastenal, but after going to two of their stores and waiting patiently (well, maybe not too) for a call back after they polled all their vendors I'm throwing in the towel for them. Does anyone know a source for odd threaded nuts? I sure would appreciate a lead or two. TIA

Re: OK here's a tough one.....

#2

Rick L

Re: Nope...easy one...

Rick L

>90521A042 part number at www.mcmaster.com

Re: OK here's a tough one.....

#3

Re: OK here *LINK*

Mark Mandell - Gone Round In Jersey

>Have your faceplates made from scratch. Contact Bill at the link. I doubt he'll be unable to set you up. Excellant work, very reasonable. Where I get all my faceplates.

mm


Seahorse Custom

Re: OK here's a tough one.....

#4

ORDERED THANX

Ron Bauman

>

Re: OK here's a tough one.....

#5

CONTACTED, THANX

Ron Bauman

>

Re: OK here's a tough one.....

#6

3 corner file

Basil

>You said "threads mashed a bit" and "Tap & die".

If the threads are boogered up just a little bit on something that size, I wouldn't spend the money for a tap and die to straighten them out. I'd use a 3-cornered file to dress the threads up then run a 'throw away' nut down it. Do a good job on the threads and you won't have to throw the nut away.

If you live in or near a good size town with a heavy equipment dealer (think CAT or other large equip), you should be able to buy a couple of nuts (all grade 8 or better at CAT) at a reasonable price. Ask for 'plow bolts' or 'cutting edge' bolts and nuts.