Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Bandsaw circle cutting jig

Posts

Bandsaw circle cutting jig

#1

Bandsaw circle cutting jig

Rick Snyder

>Built a bandsaw circle cutting jig. I have a 1/2 inch blade on the bandsaw and started to make the cut and the blade started to bind up. whats the problem? When I have seen this done (on TV), the blade they use appears to be larger than a 1/4 inch, or is that the right size. I have put in several different setting on this jig.

Thanks Rick

Re: Bandsaw circle cutting jig

#2

Re: Bandsaw circle cutting jig

Ray Binnicker

>Rick,

I use a 1/2" blade almost for everything, including circles. I use the Delta jig and don't have any problems. What size circle are you trying to cut? As long as your jig is parallel to the blade and table I don't know what could be causing your problem. Recheck your setup again and try it again.

Good luck.

Re: Bandsaw circle cutting jig

#3

Re: Bandsaw circle cutting jig

Rick Snyder

>Thanks for the response Ray. I will re-check the setup. I set the pin points at three inch intervals. Question ... should the center line of the jig be at the front tip of the blade? if so, that might be were my problem is.

Thanks Ray..... Rick

Re: Bandsaw circle cutting jig

#4

Re: Bandsaw circle cutting jig

Barry Irby

>I think you are right. The pin should be at the leading edge of the teeth, not centered on the blade.

Re: Bandsaw circle cutting jig

#5

Re: Bandsaw circle cutting jig

john lucas

>Barry is correct. the center point should be at the tip of the blade. Feed the wood slowly. If your blade doesn't track straight feeding it slowly should still allow you to cut a decent circle with a 1/2" blade.

Re: Bandsaw circle cutting jig

#6

Re: Bandsaw circle cutting jig

Lee Schierer - McKean, PA

>I agree, the tips of the teeth should be on the center of the pin so you are cutting exactly tangent to the center. If you are cutting ahead or behind that the blade will track sideways and bind/

Lee

Re: Bandsaw circle cutting jig

#7

Re: Bandsaw circle cutting jig

Rob Sandow

>I would use a 1/4" or smaller blade for circle cutting. 1/2" might work for larger diameters, but a smaller blade will work for any circle.

Rob

Re: Bandsaw circle cutting jig

#8

Re: Bandsaw circle cutting jig

Alan S

>Check the blade drift angle, and draw a line on the table through the blade at that angle. Now draw a perpendicular to that line that goes through the teeth of the blade. Your circle center should be on that line.

Keep in mind that all 1/2" blades don't cut the same radius curve. The woodslicer has very little set, which keeps the kerf narrow, and also helps keep it cutting straight, which is another way of saying that it does not cut curves well. A 1/2" blade with a lot of set will cut circles to a smaller radius; a narrower blade is the usual approach to even smaller circles.