Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

B&D/Dewalt Home Shop Radial Arm Saw Setup

Posts

B&D/Dewalt Home Shop Radial Arm Saw Setup

#1

B&D/Dewalt Home Shop Radial Arm Saw Setup

Bob Willey

>I recently bought a B&D/Dewalt Home Shop RAS built in about 1960 at a flea market . The model number is R1150. It is in very good condition.

The question I have is about the table set up. The base is a yoke similar to a heartshape . There are to two support bars that attach to the yoke and then to a wood table top. They each have a thumb screw to adjust the table top. The problem I have is the thumb screw location is forward of the base plate. Is there supposed to be a space between the table top and the rear post? If not I can not see how you would utilize the thumb screws without cutting a notch in the table top? As you can tell from my description this is my first experience with a RAS.

Re: B&D/Dewalt Home Shop Radial Arm Saw Setup

#2

Re: B&D/Dewalt Home Shop Radial Arm Saw Setup

Marv

>Hi Bob,

Yes, there is usually a space between the support post and the back edge of the table top. On mine, the top is three pieces, the larger main part, a piece that extends about an inch above the top and a narrow piece behind the piece that extends up. The piece that extends up and the back smaller piece are clamped toward the front to hold them in place. The part that extends up above the top surface of the table is for pushing the work piece against while you saw it and also acts as a fence for ripping. The screws are also used to square that fence to the saw blade. Hope this is helpful..

Marv

Re: B&D/Dewalt Home Shop Radial Arm Saw Setup

#3

Re: B&D/Dewalt Home Shop Radial Arm Saw Setup *LINK*

Mike Fitterling

>Congrats on getting a RAS; they are very useful machines. Operating and setting up a RAS is not very intuitive, and I would encourage you to educate your self on their use and tuning before firing it up and sawing wood. Because it is a Dewalt I would recommend Wally Kunkel's book, Mastering the Radial Arm Saw, which will guide you through proper tunibng and setup, and more importantly, safe operation. His book is specifically geared toward setup of Dewalt saws. Link is below.

The table is made up of three parts: a back table, a fence, and a min table. The main table is attached to the adjustment bars and then the bars are adjusted to make the table coplanar with the table surface. The fence is "pinched" between the main table a a slightly lower back table by means of thumbscrews at the back. The fence is sacrificial and can be replaced as needed.

Cheers,

Mike


http://www.mrsawdust.com