Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

OT: salvaging ceramic floor tile

Posts

OT: salvaging ceramic floor tile

#1

OT: salvaging ceramic floor tile

pecker

>I had to remove about 100 floor tiles, 9" square from an entryway for repair to the floor.

I have about 60 new ones saved from the original installation, so I'll have to clean up about 40 of the removed ones. I'd like to get as much of the thinset mortar off the bottoms as I can in a reasonable amount of time.

Any ideas how to do this? I tried soaking one in some water, then scraped at it with a wire brush and a flat screwdriver. This sorta works, but was very tedious. So if anybody knows a better way I'd appreciate it.

Re: OT: salvaging ceramic floor tile

#2

Re: OT: salvaging ceramic floor tile

Thad Parker

>wire brush/wheel mounted to a rotary tool should be less work. My FIL has a wire wheel on his bench grinder with the gaurd removed...that would be a nice setup as long as you were careful of finger placement.

Re: OT: salvaging ceramic floor tile

#3

Re: OT: salvaging ceramic floor tile

Clint Searl, at the base of Haycock Mtn

>If you have an angle grinder, use a heavy abrasive disk for metal or one of the tungsten carbide disks for wood carving.

Clint

Re: OT: salvaging ceramic floor tile

#4

Re: OT: salvaging ceramic floor tile

woody r

>I have ground the thinset off several hundred tiles with a 4 1/2"angle grinder. My fixture is a flat surface with two stops slightly thinner than the tile placed in a "v". I nest the tiles in the "v". I operate the wheel with the flat about 15 degrees to the tile. I engage the wheel to the tile so that the rotational force holds the tile down and against the stops. If I were doing 9" tiles the flat surface would have a large thru hole so that air from the grinder could not build up and raise the tile. With my small tile I start and stop the grinder directly over the tile.

Re: OT: salvaging ceramic floor tile

#5

Right

Keith Newton

>

Re: OT: salvaging ceramic floor tile

#6

Re: OT: salvaging ceramic floor tile

woody r

>Oooops... my previous post should have included "with a masonry wheel in a 4 1/2 inch grinder".

Re: OT: salvaging ceramic floor tile

#7

Re: OT: salvaging ceramic floor tile

pecker

>Thanks. The wire wheel in a hand held drill is working nicely. I've been able to do about 6 or 7 per hour this way. Although the wheel is about half it's original diameter now.