Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Flooring Transition Question

Posts

Flooring Transition Question

#1

Flooring Transition Question

Nat Robison

>I'm finishing up a basement project and need some flooring advice. I'm tiling a bathroom floor and the bathroom door will lead to an area that will be carpeted. All flooring is going over the concrete floor in the basement.

What do you suggest for a threshold/transition piece between the tile and carpet (that can be affixed to concrete)?? I was thinking of doing carpet tiles but haven't ruled out subbing it out and going the tackstrip route.

Re: Flooring Transition Question

#2

Re: Flooring Transition Question

Grant Smith

>Nat,

When I did this, I took a piece of hardwood and milled a "T" shaped transition strip. About 1 1/2" across the top of the tee and high enough so the stem of the "T" would be just right for the tile thickness. The thickness of the stem was about 3/8". I bevelled the edges of the top of the tee (which was just under 1/4" thick) and drilled holes to receive countersunk tapcons, which I installed into the concrete through the strip and colored the heads black with a Sharpie.

You can also check with your local homecenter for metal transition strips. I believe they make tile to carpet transitions that get thin-set into edge of the tile and will then clamp on to the carpet after the thin-set dries for a couple days.

FWIW,

Grant in Iowa

Re: Flooring Transition Question

#3

Marble threshold from the borg

Clint Searl, at the base of Haycock Mtn

>

Re: Flooring Transition Question

#4

Re: Flooring Transition Question

Jim Dillon

>Nat,

I've made a couple of wooden thresholds from locust that transition from a smooth tile (maybe 10x10 tiles) kitchen floor to a moderate length shag carpet (on top of concrete). If I remember right, I did cut a shallow rabbet on the underside of the carpet side to better fit the carpet and a very shallow bevel on each side of the threshold on the topside. I then fastened the threshold to the tile side with several nice beads of construction adhesive and piled books etc. on top for a day or so. Has worked fine for 5 years, but YMMV. Good luck.

Jim