Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Thrust bearings on 14" JET

Posts

Thrust bearings on 14" JET

#1

Thrust bearings on 14" JET

Lou

>While working on a project on my 14" Jet bandsaw,I noticed something strange. When I change from my 1/2 blade to anything smaller, and make my adjustment so the blade rides in the crown of the top wheel, my lower thrust bearings in not long enough to positon itself behind the blade. It appears to be about 1/8 inch shy. The lower cool blocks make it, but just barely.

I was wondering if anyone else had this problem and what do I need to do to fix it. Get a longer shaft for my thrust bearing?

Thanks for your help.

Re: Thrust bearings on 14" JET

#2

Re: Thrust bearings on 14" JET

George@Colonel's Workshop-Havertown PA

>Good Morning Lou,

There is an adjustment for the lower thrust bearing which will permit you to extend the bearing shaft to the correct adjustment. My older blue 14" Jet, and my newer 14" white machine each has this feature. Examine the saw closely when the table is removed. You'll need to readjust both upper and lower thrust bearings and blade guide blocks every time you change the blade and width of blade---or more frequently to maintain acceptable tune.

George