Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Veneer over same species

Posts

Veneer over same species

#1

Veneer over same species

Floyd

>I am building some walnut raised panel doors. I would like to put some burl veneer (or other figured walnut) on to a walnut substrate so that when I raise the panels the panels will have some interesting character. I know the walnut substrate will move but I would assume the veneer, being the same species, will move the same amount and not crack. Or, am I making a bad assumption. Will the glue move at a different rate and cause problems?

A professional cabitnet make said this is done often and that it should work fine.

Any advice would be appreciated.

Re: Veneer over same species

#2

Re: Veneer over same species

Ted Wong

>Common practice is to veneer both sides.

Re: Veneer over same species

#3

Re: Veneer over same species

Floyd

>Thanks....good point that slipped my mind.

Re: Veneer over same species

#4

Re: Veneer over same species

Bill Hylton

>I did almost exactly what you are talking about several years ago. Instead of doors, I made a frame and panel chest (like a blanket chest). I used low-quality walnut for the substrate and applied veneers resawed from a very expensive walnut crotch. Because the panels were captured in a frame, I didn't bother veneering their backs. And I didn't apply a finish to the interior of the chest either. The chest looks great, and I haven't seen any adverse effects from a lack of balance veneers on the panels, or a lack of interior finish.

Bunch of extra steps in making the panels, but worth the added time and effort.

Bill

Re: Veneer over same species

#5

Lee Grindinger

It's common practice

Lee Grindinger

>Go right ahead and use solid as your substrate. What you are contemplating is common practice in the trade. Don't use thick veneer, the standard now is around 1/40" and this thickness will accommodate substrate movement well. Thick veneer, more than 3/32" will exert itself on the substrate and eventually the glue line will fail.

Actually, the use of burl proves that it's the glue line and not the veneer that needs balancing, you can use straight grained walnut veneer on the backside for balance.

Also, in your application, run your veneers the same grain direction as the substrate, no need to reverse them.

Lee