Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Design help: accent table #2

Posts

Design help: accent table #2

#1

Design help: accent table #2

David Hay @ Denver

>I took the various suggestions I received in response to my previous request for design help and incorporated them into a new model. I like the new result much better. I made the top bigger, adjusted the rails so that the curve does not stop short of the end and moved them down so that the curve continues into the foot element on the leg. I also made the legs narrower so that they're less square.

What do you think? Better?

Thanks!

David


img

Re: Design help: accent table #2

#2

Too Many Cooks Didn't Spoil...

George@Colonel's Workshop-Havertown PA

>Good Afternoon David,

You did well to incorporate some of those ideas you received on the prototype. I liked the input then, and like your result now. Too many cooks didn't spoil the broth, and there is safety in numbers. Lastly, a camel is a horse put together by a committee. Nice job.

George

Re: Design help: accent table #2

#3

Re: Design help: accent table #2

Moses Yoder in White Pigeon, MI

>I didn't look at your first table, but this one looks good. I am wondering why the legs are a straight up and down line with the little bump out at the bottom. I think they would look better if they had a subtle curve inwards, and then instead of bumping out at the bottom they could just flare out. It would take about the same amount of time to cut them if you made a template and used a flush bit with a router, or just cut to the line and then use a scraper or spokeshave. If you were using a spokeshave anyway then you would round the outside edges slightly...