Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Follow up to my Compressor problem

Posts

Follow up to my Compressor problem

#1

Follow up to my Compressor problem

Joe in a Cleveland suburb

>Hi again.

So I took a closer look at the compressor. You can see in the image below I think "Device B" is where the problem is. The "lever A" presses up against Device B. Device B is constantly letting air out down around the little pin where the lever makes contact. I took it apart and tried to clean it. There isn't much to it really. Squirted WD-40 in it. Doesn't help. The little needle sticking out of the bottom does not look bent or anything.

This has to be a simple problem. Any more suggestions?

Thanks.

Joe


Re: Follow up to my Compressor problem

#2

Device "B" looks like a schrader valve,

Eddie Pacheco, San Jose, Ca.

>The type used in automobile tires. That's an inexpensive way to make a pressure relief valve.

If you you move device "A" away from the pin does the airleak stop?

If so this could be a simple adjustment within the small black box.

(DISCONNECT COMPRESSOR FROM POWER SWITCH) before opening the box and making any adjustments. Adjsut the screw for device "A" just a bit to make it not or just barely touch the pin.

If the leak persists even if device "A" is not touching then the schrader valve may have some debris stuck in it and it is not closing. Remove the housing from the bracket to remove and replace the schrader valve. You may get by with just cleaning it.

Good luck.

Re: Follow up to my Compressor problem

#3

Yup, that's the unloader valve.

Kent in Emmaus, PA

>