Re: OK, I'm dumb. Please "Splain"
Joe Dusel (Vista, CA)
>George,
The Franklin HiPurFormer adhesives are a polyurethane hot melt adhesive that comes in a cartridge and goes in a special (but crappy) gun made by Steinel. It's a high temperature adhesive. The gun is cordless, but it must be set into a plugged in cradle until the temperature is high enough for the adhesive to flow out of the gun with trigger pressure.
The problems are first off the glue does not like to be reheated often. There is a little valve in the cartridges meant to keep the glue inside when the trigger is not pressed and this often gets stuck. When this happens if you press the trigger harder to force it the guns break rather easily. I have gone through 3 guns so far and Franklin has been very nice at replacing them for free. The adhesive tubes also have a shelf life of around 6 months after which the adhesive does not want to come out. I'm assuming it's that little valve again. Franklin will also replace those if you complain. The tubes cost around $8 each, so it gets annoying if you have only used a small amount from a tube and $7 worth does not want to come out. This is why people resort to drilling out the valve.
The adhesive is pretty good and it sets within about 30 seconds for the fastest type and a few minutes for the slowest. You can glue just about anything together with it, but it does have a bit of thickness that you need to deal with. It's great for gluing things that are hard to clamp.
Joe