Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Streaking Walnut

Posts

Streaking Walnut

#1

Streaking Walnut

RP

>I've never used Sanding Sealer before. I turned some walnut bowls and put the sanding sealer on them. I sanded it lightly as per the directions and then applied wipe on Poly over it. The bowls took on a streaky look. Dark and light areas, shiny and dull areas.

The Sealer I was using was a water base poly, which says you can put poly over it after it dries.

Am I doing something wrong? I am not sanding through it. I stirred the sealer trying to ensure I got all the solids off the bottom of the can. It has done it twice to me.

Thanks.

RP

Re: Streaking Walnut

#2

It's unnecessary; just causes problems

Clint Searl, at the base of Haycock Mtn

>

Re: Streaking Walnut

#3

Re: Streaking Walnut

John Lucas

>Sealer is just thinned finish with Stearate in it to reduce the sandpaper clogging. It sounds like your streaking is coming from the wood soaking up finish in some areas. Just apply more finish. I quit using sanding sealer because I thin my finish anyway.

Re: Streaking Walnut

#4

Ric Taylor

Re: Streaking Walnut

Ric Taylor

>RP,

The sanding sealer I use is the celulose type from Myland's. I think most of us use sanding sealer primarily to fill pores in the wood. When I put it on, I sand it down to the bare wood. I do that between each grit of sanding, i.e. 120, sanding sealer, 180, sanding sealer, 240, sanding sealer, etc. etc., sanding to bare wood each time. This results in a very smooth sometimes glassy final surface.

Sometimes after doing this I will use my buffing wheel system to buff the wood resulting in a glassy finish without adding any other type of funish.

It sounds to me like you may have sanded to bare wood in some areas, and left sanding sealer in other areas, resulting in your uneven final finish.

You might get other ideas by posting your question over in the turning forum.

Ric