Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Cleaning Latex from paint brush (OT?)

Posts

Cleaning Latex from paint brush (OT?)

#1

Cleaning Latex from paint brush (OT?)

Barry Irby

>I have been working on a renatal house and left a nice paint brush with Semigloss latex (Valspar) sitting too long (overnight). It dried out and got crusty on one side. Is there a way to clean it without ruinning the brush? TIA

Re: Cleaning Latex from paint brush (OT?)

#2

Re: Cleaning Latex from paint brush (OT?)

Gary Ratajczak

>Try soaking in some hot (boil it first) water, then work bristles with an old comb. Did the trick for me.

Re: Cleaning Latex from paint brush (OT?)

#3

Re: Cleaning Latex from paint brush (OT?)

Joe Burke

>Lacquer thinner should loosen it up. You can try leaving it to soak for a few minutes and then use a tooth brush to "comb" out the left over paint. I do this to my latex brushes to clean out the stubborn paint that won't wash out after a typical cleaning with water.

Re: Cleaning Latex from paint brush (OT?)

#4

Re: Brush cleaner

Glenn Madsen near San Francisco

>some serious solvents that do a pretty good job of disolving old paints. I've got some paint brushes maybe 15 years old that benefit from a good cleaning, every couple of years, in light use.

Buy it at a paint store, or at the BORG. Get a brush cleaning comb as well. Brass brush and stainless steel teeth. $5 or so?

Re: Cleaning Latex from paint brush (OT?)

#5

The HandyWoman's Secret Weapon

Curly Smith

>You can soak it in vinegar. A duct tape wrapped container works best...

Re: Cleaning Latex from paint brush (OT?)

#6

I second...

Jason Roehl in Mulberry, IN

>...the brass brush/stainless comb combo brush to clean it off. Let it soak in very hot water for a few minutes first. If it was just overnight, don't bother with chemicals, though. Hot water will do just fine. Scrub it under running hot water only in a direction away from the ferrule (no side-to-side or tip-to-base scrubbing). Once the stainless scrub brush takes care of the crusties on the surface, use the comb to penetrate as near to the ferrule as you can and comb toward the tips.

Jason (pro painter)

Re: Cleaning Latex from paint brush (OT?)

#7

Liquid fabric softener

Clint Searl, at the base of Haycock Mtn

>If that doesn't work, MAP gas torch.

Clint

Re: Cleaning Latex from paint brush (OT?)

#8

Try Tretrachlorethene

Dave Anderson (Pac NW)

>you can get this from most chemical companaies It is commonly sold as a non-falmmable safty solvent.. It desolves latex faster than superman!!! just don't breathe it!!!