Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

shellac finishing

Posts

shellac finishing

#1

shellac finishing

john pohja

>Anyone ever had problems removing residual shellac dust after light sanding (up to 600 grit) of a sprayed-on shellac finish? I waited 4 weeks to let the shellac cure, and as Jeff Jewitt's book recommends, used a cloth dampened with mineral spirits to remove the residue; thats the way i've always done it, with good results. However, on this project, after the wiping-off i get a whitish, filmy, haze as though the mineral spirits just moved the dust around and then dried. This is a very dark mahogany finish so the haze really stands out. I've wiped the piece down twice and only some of the film disappears. Do i continue to wipe with MS? I'm afraid that too much MS may damage the finish. Is there a better method and/or chemical to remove this residue? Thank, John

Re: shellac finishing

#2

Re: shellac finishing

Steve Schoene

>Mineral spirits won't harm the shellac, but you will probably get "cleaner" results with naptha, which is a lighter, less oily material. I suspect what you are observing is the fact that often when we wipe off a surface we are just pushing the contamination around, not really removing it. Using a number of clean rags so that you can present a fresh surface freguently is also of benefit.

Re: shellac finishing

#3

Re: shellac finishing -"Micro fiber"

Larry Clinton At Frankfort (Central)., Indiana

>I have been using cheap "microfiber" cloths to remove sanding dust / contaminates prior to finishing. I saw ads on TV for dust cloths made from the new micro fiber material, so picked up some at a flea market (dirt cheap) on a whim. I have found that they really work for the fine sanding residue. I quit using tack cloths a couple years ago - partially due to reading about contamination from the resins. I was using rags w/ mineral spirits to clean - I used the Micro fiber cloths then wiped with a rag wet with the mineral spirits and could not detect any difference - or any contaminates on the wet rag. I'm still not 100% sure they remove all the dust - but they are doing the job for me as well as any other method I've used. I found fairly large Microfiber cloths at Homier for less than $1.00 apiece. This is a lot cheaper than using tack cloths as I (SWMBO) washes these and I can reuse then over again and again. I can't comment on how this would work in your situation as I almost always apply a coat of wax to pieces I shellac (Briewax / minwax etc.), then hand buff it out. I personally prefer the tactile "feel" and appearance of the waxed surface.

Re: shellac finishing

#4

What grit did you sand or polish with?

Derek

>If you polished or sanded the shellac with too coarse of a grit, it could be the sanding scratches you are seeing.