Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Hiding dark spot on maple door *LINK*

Posts

Hiding dark spot on maple door *LINK*

#1

Hiding dark spot on maple door *LINK*

Christel Berg

>Hi,

I recently purchased a new maple front door, and my husband got a little too overzealous with the belt sander, and uncovered a dark vein. Is there anything I can do, short of painting the door, to cover up this blemish? The plan was just to coat the door with polyurethane.

I included a link to pics of the door on flickr.

Thanks!

Christel


http://www.flickr.com/photos/christelandbro/sets/72157600467682007/

Re: Hiding dark spot on maple door *LINK*

#2

Looks like veneer

Ed Mulligan, Cape Cod

>I think door panel is veneered with vertical grain fir. The veneer has been sanded away, exposing the substrate. I can't tell what the substrate is but it might be mdf.

Painting over the sand-through is an option. Also, you might try bringing your photos to a local furniture repair shop or cabinet shop for a repair estimate.

Ed

Re: Hiding dark spot on maple door *LINK*

#3

Re: Hiding dark spot on maple door

George@Colonel's Workshop-Havertown PA

>Good Evening Christel,

I agree with Ed. The veneer has been sanded through. The defect can be professionally repaired, but it may cost more than you would want to pay. But it wouldn't cost too much to find out.

George

Re: Hiding dark spot on maple door *LINK*

#4

Re: Hiding dark spot on maple door

Stephen Shepherd in the State of Deseret

>Your husband has sanded through the veneer exposing the substrate. I don't think you need to paint. If you have the expertise, you could lay a skin of veneer over the whole flat panel, don't let your husband do it.

If you do not want to do that you might try some high quality colored pencils. Start with the lightest color or even a little lighter than the lightest color of the wood. Then apply the color in the direction of the grain of the wood. Then use a slightly darker color to enhance and replace the missing grain.

Sealing with clear shellac in between coats will seal the color in, then used to finish and protect the touch up.

Good luck, tell your husband a belt sander is never used on a finished surface.

Stephen

Re: Hiding dark spot on maple door *LINK*

#5

Dale Lenz

Re: Hiding dark spot on maple door

Dale Lenz

>How about putting a full door shot up. I'm thinking, : " )