Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Broken table saw belt-one of three

Posts

Broken table saw belt-one of three

#1

Broken table saw belt-one of three

Tony Sade (Charleston, WV)

>The belt nearest to the blade on my 5 year old, lightly used Grizzly 1023 left tilt table saw broke. To be more precise, I just noticed that the belt was off the pulley and was cracked in numerous places around its circumference. I yanked it off-didn't take much.

Couple of questions:

1. Are belts like this available at other types of stores (automotive, machine shop, etc.) or do I have to go the Grizzly for a replacement?

2. Any problem with using the saw with the two remaining belts until I get a new one? Obviously, from the looks of the dead one, I've been getting by with only two for a while.

3. Any idea what would have caused this kind of uneven wear? I haven't checked carefully (I will) but it appears the remaining two belts are fine.

4. Are these belts like tires-best to replace the entire set, rather than just one at a time?

Thanks,

---------------------

Tony

Re: Broken table saw belt-one of three

#2

Re: Broken table saw belt-one of three

Thomas S Stockton

>Tony

Yes you can run the saw with just two belts. Replace them in sets of 3, you can get them at Graingers or any bearing shop just has to be the same size, they will be better quality than what you get from Grizzly. Probably wore out because they used a cheaper belt to start withand the other 2 are probably on there way out also.

Tom

Re: Broken table saw belt-one of three

#3

Re: Broken table saw belt-one of three

Pete LaBelle

>Try NAPA or any power transmission store for replacments.

They need to be replaced as a set. All have worn some. If a new one is inserted among the old ones, it unworn shape will cause it to ride differently in the pulleys, causing it to work harder or lesser. It also has a tendancy to run the driven pulley at a slightly different speed, affecting performace on all the belts.

Suggest using a cut-side belt rather than the cheaper wrapped side belts. Better grip and no lap in the belt to bump over each revolution.

Lay a straight edge along one of the pulleys and see that both pulleys are in line with each other. Keep pulleys clean of rust, pitch and any other goo. Pulleys can be spun by hand on their respecive shafts and should run absolutely true too.

Pete

Re: Broken table saw belt-one of three

#4

Get Cog Belts they run smoother and better.

Dustmaker Mike

>

Re: Broken table saw belt-one of three

#5

Re: Broken table saw belt-one of three

Bill Tindal, E.TN

>1. I agree with everything suggested, though any ordinary belt available at local industrial supply store will last a very long time.

2. According to several reliable sources it is no longer necessary to get "matched belts" when they run in groups of 3. Now days quality control is such that all belts are "matched". So, don't let anyone talk you into paying $$$$ for "matched belts".

Re: Broken table saw belt-one of three

#6

Re: Broken table saw belt-one of three

Bob Reeve

>I sell V Belts for a major manufacturer. Yes, you must replace all 3 belts at the same time as belts strech over time and get longer. All major (not Chinese or India)mfgs of belts use a matchless system, so any 3 belts from the same mfg will work together.

Wrapped V-Belts run smoother and do not wear out the pulleys as fast. Cogged belts should only be used if you are using very small pulleys. They wear out pulleys twice as fast as wrapped.

Bob